New Holland 3006 – ECM: Coolant Temp Not Plausible With Oil Temp
Issue description
The Engine Control Module (ECM) has detected a discrepancy between the signals from the engine coolant temperature sensor and the engine oil temperature sensor. After a cold start, both temperatures should rise at a similar rate. If one sensor indicates the engine is at full operating temperature while the other suggests it is still cold, the ECM flags this as an implausible condition. This cross-check helps detect a faulty sensor or wiring issue that might not be identified by a simple open or short circuit test.
Applies to these machines
13 machines- T7 Series
- T8.275
- T8.300
- TM120
- TM130
- TM140
- TM155
- TM175
- TM190
- T6000 Series
- L-Series Skid Steer
- C-Series Skid Steer
- Backhoe Loaders
Check the cause
Check the engine coolant level to ensure it is full, as a low level or airlock can cause inaccurate temperature readings
Inspect the wiring harnesses and connectors for both the coolant and oil temperature sensors for chafing, melting, corrosion, or loose pins
Ensure all ground connections for the engine and ECM are clean and secure
Perform a cold start plausibility check using a diagnostic tool to verify both sensors read close to ambient temperature before starting
Start the engine and monitor live data to ensure both temperature readings rise at a similar pace
Check for a 5-volt reference signal from the ECM at the suspect sensor's electrical connector with the key on
Test the suspect sensor's resistance (Ohms) when cold and at operating temperature, comparing against service manual specifications (e.g., approx. 4300 ohms at 60°F and 180 ohms at 212°F)
Repair steps
Verify fault and codes
Confirm fault code 3006 is active and note any accompanying fault codes that may provide additional clues.
Isolate the faulty sensor
Based on the plausibility check and resistance tests, determine whether the coolant or oil temperature sensor is providing the static or illogical reading.
Prepare for sensor replacement
Allow the engine to cool completely. Partially drain the engine coolant if replacing the coolant sensor, or prepare for oil spillage if replacing the oil temperature sensor.
Replace the faulty sensor
Unplug the electrical connector, remove the old sensor, and install the new sensor ensuring clean threads. Tighten to the manufacturer's specified torque without overtightening, then reconnect the harness.
Refill fluids and verify repair
Refill the engine coolant or top off the engine oil. Clear the fault codes using a diagnostic tool, start the engine, bring it to operating temperature, and monitor live data to ensure plausible readings and no leaks.
Parts you might need
(8)For T6 and T7 series tractors with FPT engines (2-pin NTC)
- Engine Coolant Temperature Sensor500382599
For T8 and TM series tractors (crosses to 82017881)
For T8 and TM series tractors
- Engine Coolant Temperature Sensor504264463
OEM New Holland / CNH
Engine Coolant Temperature Sensor
85802504OEM New Holland / CNH
Engine Coolant Temperature Sensor
87341875OEM New Holland / CNH
Combined 4-pin sensor for Cummins engines
OEM New Holland / CNH
Get help to fix this fault by requesting a quote