3012

New Holland 3012 – Engine Control Module (ECM): Left Hand Ground Speed Sensor Detects Excessive Wheel Speed

Issue description

The fault code 3012 actually corresponds to 'Air Intake Temperature Sensor - (via CAN) No Signal', but this procedure addresses the provided description of a left hand ground speed sensor detecting excessive wheel speed. A faulty ground speed sensor can lead to erratic speedometer readings, incorrect gear shifting, and the illumination of a general transmission fault light on the dashboard.

Applies to these machines

  • T4
  • T6
  • T7
  • T8
  • Workmaster 50
  • Workmaster 60
  • Workmaster 70
  • Boomer Series
  • TS-A Series
  • T8000 Series
  • TS115A
  • T8050

Check the cause

  1. Verify the fault code on the tractor's diagnostic screen to ensure the correct diagnostic path is being followed.

  2. Inspect the wiring harness and connectors leading to the ground speed sensor for any signs of damage, corrosion, or loose connections caused by dust, moisture, or vibration.

  3. Check the fuses related to the transmission and instrumentation controllers, as a blown fuse can cause a loss of power to the sensor or controller.

  4. Locate the sensor on the rear axle housing or transmission case and inspect it for physical damage, such as a cracked tip, which could indicate contact with internal components.

  5. Check for other related fault codes, such as a low 5-volt reference voltage (e.g., code 2054), which could point to a broader electrical issue affecting multiple sensors.

Repair steps

  1. Confirm the fault

    After performing the initial diagnostic checks and confirming the sensor is the likely cause, proceed with the replacement.

  2. Access the sensor

    Depending on the tractor model, remove any obstructing components to gain access to the sensor (for example, the hydraulic filter may need to be removed on a TS115A).

  3. Remove the old sensor

    Disconnect the electrical connector and carefully unscrew the old sensor from its housing. Note that these sensors can be very tight.

  4. Install the new sensor

    Screw in the new sensor and tighten it to the manufacturer's specified torque, if available. Be careful not to damage the new sensor during installation.

  5. Reconnect components

    Reconnect the electrical harness and re-install any components that were removed to access the sensor.

  6. Clear codes and calibrate

    Start the tractor and clear the fault codes using the onboard diagnostics or a service tool. Perform a speed calibration procedure if required by your specific model.

  7. Verify operation

    Test drive the tractor to ensure the speedometer is reading correctly and that any transmission shifting issues have been resolved.

Parts you might need

(4)
  • Listed for various New Holland agricultural tractors. Alternate part number: 86027316.

  • Fits a wide range of tractors including T4, T6, T7, T8, and Workmaster series. Alternate part numbers: 87564756, 84169162.

  • True Ground Speed Radar Sensor

    228760A1

    Found on models like the T8050; measures speed over the ground independent of wheel slip.

  • Used for precise application rates.

Get help to fix this fault by requesting a quote

Browse other New Holland codes