3057

New Holland 3057 – ECU: Cold Start Heater Monitoring - Not Plausible

Issue description

The Engine Control Unit (ECU) has detected an issue with the cold start heater (intake grid heater) monitoring function. The feedback signal from the heater's monitoring circuit is illogical or does not align with the expected operational state, such as an incorrect current draw or a discrepancy between the heater's on/off command and the resulting feedback. This indicates the monitoring process is not functioning as expected and may affect the proper operation of the cold start heater during engine startup.

Applies to these machines

  • TS115A
  • L180
  • L190

Check the cause

  1. Verify operating conditions: The grid heater only activates when coolant temperature is below a specific threshold (e.g., -1.5°C or -3°C). Lack of activation in warm weather is normal.

  2. Check system configuration: Ensure the grid heater is enabled in the tractor's electronic control system (e.g., H3 configuration menu).

  3. Inspect the main fuse and grid heater relay for failures.

  4. Visually and electrically inspect the wiring harness and connectors for the grid heater, relay, and coolant temperature sensor for damage, loose connections, or corrosion.

  5. Test the grid heater element: Verify 12 volts reach the power terminal during cold conditions when the 'wait to start' light is on, and check for near 0 ohms resistance to ground with the key off.

  6. Test the coolant temperature sensor to ensure it is not providing an incorrectly high reading that prevents heater activation.

Repair steps

  1. Address identified issue

    Based on the diagnostic checks, address the identified issue.

  2. Enable grid heater configuration

    If the grid heater is disabled in the settings, access the appropriate controller menu (e.g., HA or HB controller) and enable it.

  3. Replace fuse or relay

    Replace any blown fuses with one of the correct amperage. If the relay is faulty, replace it.

  4. Repair wiring and connectors

    Repair any damaged sections of the wiring harness and clean or replace any corroded connectors.

  5. Replace grid heater element

    If the heater element has an open circuit or is otherwise damaged, it must be replaced.

  6. Replace coolant temperature sensor

    If the sensor is providing inaccurate readings, replace it to ensure the ECU receives the correct temperature for activating the cold start system.

  7. Clear codes and verify

    After performing the repair, clear the fault code and attempt to start the engine in cold conditions to verify that the heater is functioning correctly and the code does not reappear.

Parts you might need

(9)
  • Grid Heater Element (Intake Heater)

    Generic component, verify by specific machine model

  • Grid Heater Relay/Solenoid

    Generic component, verify by specific machine model

  • Coolant Temperature Sensor

    Generic component, verify by specific machine model

  • Mentioned for mechanical engines; applicability to this specific fault/model is unconfirmed

  • Kit includes Heater #2854837, Harness #47578740, and hardware

  • Grid Heater Kit (Alternative/Older)

    87397276
  • Grid Heater Jumper Wire Harness

    47783144
  • Grid Heater Stage Wire Harness

    90380090

Get help to fix this fault by requesting a quote

Browse other New Holland codes