New Holland 3090 – ECM: Camshaft Sensor No Pulse
Issue description
The Engine Control Module (ECM) has detected a lack of pulse signal from the camshaft position sensor. This indicates a potential issue with the sensor's ability to generate or transmit a signal to the controller. Without this signal, the ECM cannot determine the correct rotational position of the camshaft to precisely control fuel injection timing and synchronize it with the crankshaft, which can lead to various engine performance issues.
Applies to these machines
22 machines- T4.75
- T4.80
- T4.85
- T4.95
- T4.105
- T4.115
- T4.100F
- T4.110F
- T4.80F
- T4.90F
- T5.95
- T5.105
- T5.115
- WORKMASTER
- BOOMER
- SR175
- SV185
- TD5
- TD4F
- T5 Electro Command
- T5 Dual Command
- TK4
Check the cause
Verify that the battery voltage is adequate (above 12.1V), as low voltage can trigger ghost fault codes in electronic systems.
Inspect the main ground connections to the chassis and engine block, ensuring they are clean and tight.
Visually inspect the wiring harness leading to the camshaft position sensor for any signs of chafing, cuts, or heat damage.
Unplug the sensor connector and check for corrosion, dirt, oil contamination, or moisture on the terminals, and ensure pins are straight and tight.
If equipped with a 3-wire Hall-effect sensor: Check for reference voltage (5V or 12V) at the power wire and good continuity to chassis ground. Back-probe the signal wire while cranking; voltage should fluctuate between 0V and 5V.
If equipped with a 2-wire variable reluctance sensor: Measure internal resistance across the terminals and compare to manufacturer specifications. Measure AC voltage output while cranking; it should generate a small AC voltage that increases with engine speed.
Repair steps
Prepare machine
Park the machine on a level surface and engage the parking brake. Disconnect the negative battery terminal to prevent electrical shorts.
Locate and remove old sensor
Locate the camshaft position sensor (typically on the engine block, cylinder head, timing cover, flywheel housing, or front engine cover). Disconnect the electrical connector, remove the single retaining bolt (commonly 10mm), and gently twist and pull the sensor to remove it.
Install new sensor
Lightly lubricate the O-ring on the new sensor with clean engine oil. Carefully insert the new sensor into its mounting hole, reinstall the retaining bolt to the specified torque (do not overtighten), and reconnect the electrical connector until it clicks.
Finalize repair
Reconnect the negative battery terminal. Start the engine and let it run for several minutes. Use a diagnostic tool to clear the fault code from the ECM.
Parts you might need
(4)- Engine Camshaft Position Sensor5801600537
Listed for New Holland T4 and T5 series tractors.
- Engine Camshaft Position Sensor504048261
Listed for New Holland T4, T5, TD5, TD4F, T5 Electro Command, T5 Dual Command, and TK4 series tractors.
- Engine Camshaft Position SensorMT40273644
Listed for various New Holland WORKMASTER and BOOMER compact tractors.
- Engine Camshaft Position SensorSBA185746170
Listed for Perkins engines used in some New Holland skid steer loaders like the SR175 and SV185.
Get help to fix this fault by requesting a quote