3117

New Holland 3117 – ECU: ECU Power Failure During Engine Operation

Issue description

Fault code 3117 indicates that the Engine Control Unit (ECU) lost power improperly while the engine was running or during the engine shutdown process. This typically occurs when the power supply is cut off abruptly, such as via a battery disconnect switch instead of the normal keyswitch-off procedure. This improper shutdown can lead to erratic system behavior, failure to function correctly, and a potential engine derate where the ECU limits power to protect the engine.

Applies to these machines

  • T4
  • T5
  • T6
  • T7
  • T8
  • TM
  • TS
  • T7.200
  • Boomer
  • TC

Check the cause

  1. Test the battery with a load tester (not just a multimeter) and check for a malfunctioning alternator to ensure voltage is stable between 13.8 and 14.4 volts when the engine is running

  2. Check all fuses and relays related to the ECU and main power supply, including the main fuse located near the battery

  3. Inspect all ground straps for corrosion, damage, or looseness

  4. Test the ignition switch for wear or faults that could cause a momentary loss of power during machine vibration

  5. Carefully inspect the wiring harness and connectors leading to the ECU for signs of corrosion, damage, or loose pins

  6. Test for voltage directly at the ECU fuse socket to confirm if power is present

Repair steps

  1. Review fault codes

    Use a diagnostic tool to confirm the presence of fault code 3117 and check for any other associated codes.

  2. Service battery and grounds

    If the battery fails a load test, replace it. Clean or replace any corroded or loose ground straps to ensure a solid electrical connection.

  3. Replace ignition switch

    If the battery and connections are good but power output from the ignition switch is inconsistent, replace the faulty ignition switch.

  4. Repair wiring harness

    Check for continuity and voltage at various points in the ECU circuit. Repair any damaged wires or corroded connectors, paying special attention to the instrument cluster connector on TM and TS models.

  5. Replace Engine Control Unit (ECU)

    If all wiring, switches, and power sources are verified good and the ECU is confirmed faulty, replace the ECU. Note that a new ECU may require programming by a certified technician.

Parts you might need

(11)
  • Fits various compact track loaders, backhoes, and utility tractors

  • For T6/T7 series

  • Engine Control Unit (ECU)

    5801811458

    For T7.200

  • Genuine New Holland part

  • For Boomer, T, and TC series

  • For various skid steer loaders and combines

  • Heavy-duty tractor battery

    Verify correct spec for machine

  • Earth strap set

    Generic replacement for corroded grounds

  • Battery terminal clamps

  • Electrical contact cleaner

  • Dielectric grease

Get help to fix this fault by requesting a quote

Browse other New Holland codes