3200

New Holland 3200 – ECU: Cylinder 4 Warning - Open Load

Issue description

The Engine Control Unit (ECU) has detected an incomplete electrical path (open circuit) in the circuit for the cylinder 4 fuel injector. This prevents the injector from receiving the proper operating signal, which can be caused by a break in the wiring, a loose connection, or a failure within the injector's internal coil. This condition typically results in engine misfiring, rough running, hesitation, and a loss of power.

Applies to these machines

  • T5.95
  • T5.105
  • T5.115
  • T5060
  • T8 Series

Check the cause

  1. Visually inspect the wiring harness leading to the cylinder 4 fuel injector for chafing, cuts, or corrosion on the connectors.

  2. Ensure the electrical connector is securely fastened to the injector, as a loose connection is a common cause for an open load fault.

  3. Perform a continuity test on both the power and ground wires running between the ECU connector and the injector connector to check for broken wires.

  4. Perform a wiggle test on the wiring harness while monitoring continuity with a multimeter to pinpoint any intermittent breaks.

  5. Measure the injector coil resistance across its two electrical terminals. Compare to manufacturer specs (typically 10-15 ohms); an infinite reading indicates a failed, open injector coil.

Repair steps

  1. Prepare machine for service

    Park the tractor on a level surface, engage the parking brake, turn off the engine, and disconnect the battery before beginning any electrical repairs.

  2. Access the injector

    Remove engine covers or other components as necessary to gain access to the fuel rail and the number 4 injector.

  3. Perform diagnostic checks

    Follow the diagnostic steps outlined above to determine if the fault lies with the wiring, the connector, or the injector itself.

  4. Repair or replace wiring

    If a break or damage is found in the wiring harness, repair it using appropriate connectors and heat-shrink tubing. If the damage is extensive, replace the entire harness section.

  5. Replace the fuel injector

    If diagnostic tests confirm that the injector coil is open (infinite resistance), replace the injector. Always replace its associated seals to prevent fuel leaks.

  6. Reassemble and clear codes

    Reassemble all components and reconnect the battery. Use the New Holland Electronic Service Tool (EST) to clear the fault code from the ECU's memory.

  7. Verify the repair

    Start the engine and let it run to ensure the fault code does not reappear and that the engine is operating smoothly.

Parts you might need

(5)
  • OEM part. Alternate OEM numbers: 0445110457, 0986435254, 504091504. Remanufactured option: 5801790338R.

  • Replaces older part number 2856255. Remanufactured option: 2856255R.

  • Fuel Injector (General)

    87298764

    Remanufactured option, specific model fitment not specified.

  • Cross-references: 504194432, 2855135, 500060542. Always verify fitment by serial number.

  • Common Rail Fuel Injector (Bosch)

    0445120073

    Alternate Bosch part number: 0445120075

Get help to fix this fault by requesting a quote

Browse other New Holland codes