New Holland 3324 – ECU: Timeout of CAN Message EBC1
Issue description
The Engine Control Module (ECM) has lost communication with the Electronic Brake Controller or the module responsible for broadcasting the EBC1 CAN message. The ECM expects to receive regular updates over the CAN bus regarding the brake status (e.g., ABS active status, ASR engine active status). When this message is not received within the expected timeframe, the system logs a timeout error.
Applies to these machines
12 machines- T8.275
- T8.300
- T8.330
- T8.360
- T8.390
- T8.420
- T8.435
- T8010
- T8020
- T8030
- T8040
- T8050
Check the cause
Visually inspect the wiring harness leading to and from the brake pedal switch(es) for chafing, cuts, pinching, or heat damage
Examine electrical connectors at the brake switch and the ECU for corrosion, bent or pushed-out pins, and ensure they are securely seated
Perform a CAN Bus Resistance Check (Power OFF) at a known CAN connector; resistance between CAN_H and CAN_L should be approximately 60 Ohms
Perform a CAN Bus Voltage Check (Power ON) measuring DC voltage to ground; CAN_H should be 2.5-3.5V and CAN_L should be 1.5-2.5V
Test the brake switch functionality for proper continuity when the pedal is actuated
Repair steps
Repair wiring and connectors
Repair any obvious wiring damage or clean corroded connectors found during the initial diagnostic checks. Clear the fault codes and operate the machine to see if the fault returns.
Isolate the faulty component
Disconnect the brake switch from the CAN network. If the communication on the rest of the network stabilizes (verify with a diagnostic tool), the switch itself is the likely culprit.
Check power and ground
Verify that the brake switch is receiving the correct voltage and has a solid ground connection at its connector. A loss of power or ground will prevent communication.
Replace the electronic brake switch
If the wiring, power, and ground are all confirmed to be good, and the fault persists, replace the electronic brake switch.
Final verification
After replacing the switch, clear all fault codes from the ECU. Start the machine and operate the brake pedal multiple times to ensure the EBC1 message is being transmitted correctly and that fault code 3324 does not reappear.
Parts you might need
(6)Cross-references: 87774411, 414144A1. Compatible with T8000 and T8 series.
Park Brake Switch
84130633Alternative/related brake switch part number. Also cross-references 84142375.
- Hand Brake Switch82005257
Alternative/related brake switch part number. Also cross-references 84142375.
- Parking Brake Switch84142375
Fits New Holland T7 series, TM series, TS series, etc.
- Parking Brake Switch87364942
Fits New Holland TS series and compatible models
- Park Brake Switch47132449
Fits New Holland TM115-TM150, TS90-TS115
Get help to fix this fault by requesting a quote