New Holland 3325 – ECU: Timeout of CAN Message ETC1
Issue description
The Engine Control Unit (ECU) has not received the expected Electronic Transmission Controller 1 (ETC1) message from the Transmission Control Unit (TCU) within the predetermined timeframe. This indicates a communication breakdown on the J1939 CAN bus network, preventing the engine from receiving critical transmission status data and potentially causing operational issues.
Applies to these machines
9 machines- T8.275
- T8.300
- T8.330
- T8.390
- TS100A
- TS110A
- TS115A
- TS125A
- TS135A
Check the cause
Visually inspect the wiring harness and connectors between the Engine Control Unit (ECU) and the Transmission Control Unit (TCU) for chafing, corrosion, loose connections, or pinched wires.
Check battery and power supply voltage. Ensure the battery is fully charged (above 12.1V) and verify all power and ground connections to the ECU and TCU are clean and tight.
Perform a CAN bus resistance check with the ignition OFF and battery disconnected. Measure resistance between CAN High and CAN Low (should be approximately 60 Ohms).
Perform a CAN bus voltage check with the battery reconnected and ignition ON (engine off). CAN High to chassis ground should be 2.5-3.0V, and CAN Low to chassis ground should be 2.0-2.5V.
Repair steps
Isolate the faulty component
If CAN bus resistance and voltage checks are abnormal, disconnect modules from the CAN network one at a time and re-measure resistance. If resistance returns to a normal 60 Ohms, the disconnected module or its connector is likely the source of the fault.
Check individual modules
Disconnect the suspected module and check the internal resistance between its CAN pins to verify if the internal 120 Ohm terminating resistor is intact or if the module has failed.
Test wiring segments
Disconnect both the ECU and TCU. Check for continuity on the CAN High and CAN Low wires between the two connectors. Also, check for any short circuits between the CAN wires and to power or ground.
Replace faulty components
Replace the identified faulty control module or damaged wiring harness section. After replacement, clear the fault codes and verify that communication has been restored.
Parts you might need
(7)Standard replacement part, verify fitment by serial number
Remanufactured option
Alternative to 87313290 for TSA Series
Transmission Electronic Control Unit (TCU/TCM) - TJ/STX Series
391112A2For TJ/STX Series
- CAN Bus Wiring Harness82036572
Verify fitment by serial number
CAN Bus Wiring Harness
84605450Fits various models, verify fitment by serial number
Main Wire Harness
47401109Harness part numbers are highly specific to the exact machine model and configuration; verify fitment via the CNH parts catalog using the machine's PIN/Serial Number.
Get help to fix this fault by requesting a quote