3402

New Holland 3402 – IC: Engine Start - Fuel Solenoid - Open Circuit

Issue description

The fault code indicates an open circuit in the fuel shutoff solenoid's electrical circuit during the engine start process. This occurs when the Instrument Cluster (IC) commands the solenoid to open but detects a loss of continuity, which can be caused by broken wiring, a failed solenoid coil, or a poor connection. This condition will prevent the engine from starting properly or cause it to shut down, as the solenoid controls fuel flow to the injection system.

Applies to these machines

  • L213
  • L215
  • L218
  • L220
  • L223
  • L225
  • L230
  • C227
  • C232
  • C238
  • 5635
  • 6635
  • TD75D
  • TN70

Check the cause

  1. Visually inspect the wiring harness leading from the instrument cluster to the fuel shutoff solenoid for chafed or broken wires, loose connectors, or corrosion

  2. Disconnect and reconnect the electrical connectors at both the fuel solenoid and the instrument cluster to ensure a secure connection

  3. Using a multimeter, check for voltage at the fuel solenoid's electrical connector when the ignition is turned to the 'ON' or 'START' position

  4. Disconnect the fuel solenoid and measure the resistance across its terminals with a multimeter (an infinite reading indicates an open circuit within the coil)

  5. Perform a bypass test by carefully applying battery voltage directly to the solenoid terminals to see if it clicks and allows the engine to start

Repair steps

  1. Isolate the fault

    Based on diagnostic checks, determine if the failure is a faulty fuel solenoid or a break in the wiring harness.

  2. Repair wiring

    If a broken wire or damaged connector is found, splice in a new section of wire with sealed connectors or replace the damaged terminal. Ensure all repairs are insulated and protected from the elements.

  3. Replace the fuel solenoid

    If the solenoid coil is open, disconnect the negative battery terminal, locate the solenoid on the fuel injection pump, disconnect it, and carefully unscrew it (be prepared for minor fuel spillage). Install the new solenoid ensuring seals/O-rings are seated, torque to manufacturer specification, and reconnect the electrical connector and battery terminal.

  4. Verify repair

    Turn the ignition on, clear the fault codes using the onboard diagnostic display or service tool, and start the engine to confirm the 3402 code does not reappear.

Parts you might need

(4)
  • Substitute for 2852741 and A77753. Fits models like 5635, 6635, TD75D, TN70.

  • Verify fitment by serial number.

  • Fuel Shut-Off Solenoid

    E8NN9D278AA

    Replaces CAV 7167-620A, 7167-620B, 83981012, 9986316.

  • Fuel Shut-Off Solenoid

    E9HN9N392AB

    Verify fitment by serial number.

Get help to fix this fault by requesting a quote

Browse other New Holland codes