3528

New Holland 3528 – ECU: NOx Sensor Plausibility Failure

Issue description

The Engine Control Unit (ECU) has detected a plausibility issue with the NOx sensor signal, indicating that the signal received is not within expected parameters under current operating conditions. The sensor's readings may be illogical, stuck at zero, or not changing in response to engine load when compared to other parameters like exhaust temperature or a secondary NOx sensor. This affects the engine's ability to properly monitor and control emissions.

Applies to these machines

  • T6
  • T7
  • T8
  • T9
  • T7.165S
  • T7.225
  • T8.320
  • T8.435
  • CR
  • CR6.80
  • CR7.90
  • CR10.90
  • Magnum
  • Magnum 180
  • Magnum 250
  • Magnum 340
  • Magnum 380
  • Puma
  • Puma 150
  • Puma 165
  • Steiger
  • 5140
  • 6140
  • 7240
  • Patriot

Check the cause

  1. Read all fault codes using a diagnostic tool to check for related SCR system, DEF quality, or CAN bus communication errors.

  2. Visually inspect the NOx sensor wiring harness and connectors for chafing, melting near the exhaust, corrosion, or pinched wires.

  3. Remove and inspect the sensor head for contamination (black soot indicates oil consumption issues; white crystalline deposits indicate excessive or poor-quality DEF injection).

  4. Monitor live data from the NOx sensors on a warmed-up engine to see if readings are stuck at zero, identical between upstream and downstream sensors, or unresponsive to engine load.

  5. Evaluate SCR catalyst efficiency if both sensors appear to read correctly but the plausibility fault persists.

Repair steps

  1. Disconnect battery

    Disconnect the vehicle's battery before starting work on electrical components for safety.

  2. Remove faulty sensor

    Unplug the electrical connector from the module, unbolt the module from the chassis, and carefully unscrew the sensor probe from the exhaust bung using a specialized NOx or oxygen sensor socket. Apply penetrating oil if seized.

  3. Clean exhaust threads

    Clean the threads in the exhaust bung using an M20 x 1.5 thread chaser to ensure the new sensor installs smoothly and seals correctly.

  4. Install new sensor

    Hand-thread the new sensor probe into the exhaust bung to prevent cross-threading. Tighten to the manufacturer's specified torque. Mount the module securely to the chassis and plug in the electrical connector until it clicks.

  5. Clear faults and perform relearn

    Reconnect the battery, clear all fault codes from the ECU, and initiate a relearn/calibration procedure using a diagnostic tool. Perform a test drive or run the machine under load to complete the procedure and verify the repair.

Parts you might need

(9)
  • NOx Sensor84414466

    May be superseded by or an alternative to 5WK96711C

  • NOx Sensor47688088

    Cross-references to 5WK97262, 84422747, 51515734

  • NOx Sensor48011210
  • NOx Sensor (Remanufactured)

    47457712R

    Remanufactured part, original is 47457712

  • Alternative/Superseded CNH part number

  • NOx Sensor

    5WK96711C

    OEM Manufacturer (Continental / Vitesco); Compatible with earlier revisions 5WK96711A and 5WK96711B

  • NOx Sensor (Cojali)

    2269061

    Aftermarket option

  • NOx Sensor (Febi Bilstein)

    182738

    Aftermarket option

  • NOx Sensor (MEC-DIESEL)

    710310M

    Aftermarket option

Get help to fix this fault by requesting a quote

Browse other New Holland codes