New Holland 3577 – ECU: Active DCU Error
Issue description
The Engine Control Unit (ECU) has detected an active internal error within the Dosing Control Unit (DCU). The technical description is 'DM1DCU SPN1 message - Error in DCU active', meaning the DCU, which manages the injection of Diesel Exhaust Fluid (DEF) into the exhaust stream, has reported a general fault to the main engine controller. This can lead to reduced engine performance, engine derating, or engine shutdown to prevent non-compliance with emissions standards.
Applies to these machines
6 machines- 5130
- 6130
- 7130
- 7230
- 8230
- 9230
Check the cause
Review additional fault codes for NOx sensors, DEF quality, DEF pressure, or CAN communication to provide diagnostic direction
Inspect DEF quality and level; if history is unknown or fluid is old, drain the tank and refill with fresh, certified DEF
Visually inspect the entire DEF system (tank, lines, pump, injector) for leaks or white crystal formations
Remove and inspect the DEF dosing injector for crystallization or blockage, and perform a DEF injector quantity test to verify a uniform spray pattern
Verify DEF pump pressure using a diagnostic tool to ensure it is stable and within manufacturer specifications
Inspect all electrical connectors to the DCU, DEF pump, and SCR system sensors for corrosion, damage, or loose connections
Inspect NOx sensors and their wiring for damage or corrosion, as their failure can contribute to general SCR faults
Repair steps
Confirm diagnosis
Ensure all other possibilities have been exhausted before ordering a replacement. The DCU is an expensive component and many are returned under warranty with no fault found.
Disconnect battery
Disconnect the negative battery terminal to ensure the system is powered down before beginning the replacement.
Remove old DCU
Locate the DCU mounted on the chassis near the SCR system components. Disconnect all electrical and fluid line connections before unbolting the module from its mounting bracket.
Install new DCU
Mount the new Dosing Control Unit and securely reconnect all electrical and fluid lines.
Program new DCU
Perform software installation for the new DCU. This must be performed by a certified New Holland dealer with the appropriate diagnostic tools, as CNH will not issue the necessary passwords without evidence of prior troubleshooting.
Clear codes and test
Clear all fault codes from the ECU. Start the engine, allow it to reach operating temperature, and operate the machine under a load to allow the SCR system to perform a self-check and confirm the repair.
Parts you might need
(3)Requires software installation by a dealer upon replacement.
- DENOX module filter element84254852
Associated part that may be needed during repair.
- Filter cap repair kit47401714
Associated part that may be needed during repair.
Get help to fix this fault by requesting a quote