3577

New Holland 3577 – Engine: Dosage Control Unit Error: Urea Tank Is Empty

Issue description

The Engine control module has logged a Dosage Control Unit (DCU) error indicating that the Diesel Exhaust Fluid (DEF) or urea tank is empty, or the system falsely believes it to be empty. Technically described as a 'DM1DCU SPN1 message - Error in DCU active', this fault means the Selective Catalytic Reduction (SCR) emissions control system has detected a lack of fluid or a sensor malfunction, which will affect the proper operation of the emissions control system.

Applies to these machines

  • T7 Series
  • T8 Series
  • 5130
  • 6130
  • 7130
  • 7230
  • 8230
  • 9230

Check the cause

  1. Visually inspect the DEF tank level to verify if it is empty or low

  2. Inspect DEF quality for old, contaminated, or crystallized fluid. If the fluid quality is suspect, the tank should be drained and flushed with distilled water before refilling.

  3. Examine the wiring harness and connectors leading to the DEF tank level sensor and the Dosage Control Unit for damage, corrosion, chafing, or loose connections

  4. Inspect the DEF tank, lines, and injector for any signs of leaks (often visible as white crystal deposits) or blockages

Repair steps

  1. Refill DEF and perform drive cycle

    Fill the tank with fresh, ISO 22241 certified DEF. Operate the machine under a load for 20-45 minutes to allow the system to perform a drive cycle and reset the fault automatically.

  2. Test DEF level sensor

    If the fault persists after refilling, use a diagnostic scan tool to read live data from the DEF level sensor. If the readings are erratic or do not change after refilling, the sensor is likely defective.

  3. Perform system reset

    If a drive cycle does not clear the code, perform a forced reset using a compatible diagnostic scanner to clear stored fault codes from the engine control module's memory. A 'relearn' procedure may also be required.

  4. Replace faulty components

    If diagnostic tests confirm a component failure, replace the DEF level sensor or the Dosage Control Unit (DCU). Note that replacing the DCU may require software installation and calibration by an authorized dealer.

Parts you might need

(5)
  • OEM New Holland part. May require software installation and calibration by a certified technician. Fits various combine models.

  • DEF Level Sensor

    47973098

    OEM New Holland part. Verify correct part number for your specific machine's model and serial number.

  • Also listed for Case IH.

  • DEF Level Sensor

    47655476

    New Holland Construction.

  • Replaces 47520143, 84553250.

Get help to fix this fault by requesting a quote

Browse other New Holland codes