New Holland 3587 – ECM: Invalid Temperature Reading Before Catalytic Converter
Issue description
The Engine Control Module (ECM) has detected that the temperature reading from the sensor located before the catalytic converter is invalid, illogical, or outside its expected range. This plausibility error indicates a potential disruption to the Selective Catalytic Reduction (SCR) emissions system, which can affect catalytic neutralization and may force the machine into a derated 'limp mode' to prevent damage and maintain emissions compliance.
Applies to these machines
6 machines- T7 Series
- T8 Series
- T9 Series
- Boomer Series
- Compact Track Loaders
- T-Series
Check the cause
Visually inspect the wiring harness and connector for the pre-catalyst exhaust temperature sensor for chafing, melting, corrosion, or loose connections
Scan for related fault codes (such as 3586, 3588, or 3589) that might indicate broader SCR system or temperature plausibility issues
Monitor live data for the 'temperature before catalyst' sensor using a diagnostic tool; the temperature should rise steadily as the engine warms up (erratic or unchanging values indicate a fault)
Measure the sensor's resistance with a multimeter (infinite resistance indicates an open circuit, while a very low reading suggests a short circuit)
Verify the SCR system is communicating properly with the engine ECU via the CAN bus, and check for correct voltage and a solid ground connection
Repair steps
Safety First
Ensure the machine is parked on a level surface, the parking brake is engaged, and the engine is turned off and has cooled down completely. Disconnect the battery before starting any electrical repairs.
Locate the Sensor
Identify the exhaust temperature sensor located in the exhaust pipe just before the main SCR catalyst housing.
Disconnect and Remove
Disconnect the electrical connector from the sensor. Carefully unscrew the sensor from the exhaust pipe. Penetrating oil may be necessary if the sensor is seized due to heat and corrosion.
Install the New Sensor
Thread the new temperature sensor into the exhaust pipe and tighten it to the manufacturer's specified torque. Be careful not to overtighten.
Reconnect and Secure
Attach the electrical connector to the new sensor, ensuring it clicks into place. Secure the wiring harness away from hot exhaust components.
Clear Fault Codes
Reconnect the battery. Use a diagnostic scanner to clear the 3587 fault code and any other related inactive codes.
Perform a System Verification
Start the engine and allow it to reach operating temperature. Perform a drive cycle or a stationary regeneration if required by the service manual to allow the ECU to verify that the repair was successful and the sensor is reading correctly.
Parts you might need
(3)- Exhaust Temperature Sensor87482353
Listed as applicable for New Holland T7, T8, and T9 series tractors. This is a PTC (Positive Temperature Coefficient) type sensor.
- Exhaust Gas Temperature Sensor47478880
This sensor monitors exhaust gas temperature and sends signals to the ECU to optimize combustion and protect the engine.
Also referred to as a turbine temp sensor, used in various compact track loaders.
Get help to fix this fault by requesting a quote