3589

New Holland 3589 – ECM: Excessive SCR Catalyst Temperature Difference

Issue description

The Engine Control Module (ECM) has detected an illogical or implausible temperature difference between the SCR inlet and outlet temperature sensors. During normal operation and regeneration, the system expects a specific temperature relationship across the catalyst. An excessive difference indicates a potential failure in the catalytic converter itself, an exhaust leak introducing ambient air, or a faulty temperature monitoring sensor, compromising the system's ability to manage the catalytic process.

Applies to these machines

  • New Holland T6 Series Tractors
  • New Holland T7 Series Tractors
  • New Holland T8 Series Tractors
  • New Holland FR Combines
  • New Holland CX Combines

Check the cause

  1. Visually inspect the entire exhaust aftertreatment system for exhaust leaks between the SCR inlet and outlet sensors, and check for physical damage to the catalyst housing

  2. Check for other active or inactive fault codes related to NOx sensors, DEF quality, or the DEF dosing system, as these can indirectly cause temperature issues

  3. Inspect the wiring harnesses and connectors for both the SCR inlet and outlet temperature sensors for heat damage, corrosion, chafing, or loose pins

  4. Perform a sensor plausibility test using a diagnostic tool with the engine off and cold; readings from both sensors should closely match ambient air temperature

  5. Monitor temperature sensor readings during a parked regeneration or steady load operation to verify expected temperature rises (outlet should rise and be slightly lower than or equal to the inlet)

  6. Perform a sensor resistance test with a multimeter and compare to OEM specifications if a sensor is suspected to be faulty

Repair steps

  1. Address related fault codes

    Diagnose and repair any other active aftertreatment system fault codes before proceeding with temperature sensor repairs.

  2. Repair exhaust leaks

    Seal or repair any exhaust leaks found between the SCR inlet and outlet sensors to prevent cooler ambient air from skewing the outlet temperature readings.

  3. Repair sensor wiring

    Repair or replace damaged sections of the sensor wiring harness and ensure all connectors are clean and secure.

  4. Replace faulty temperature sensor(s)

    Replace the identified faulty sensor(s). Apply high-temperature anti-seize to the threads (avoiding the probe), hand-thread to prevent cross-threading, and torque to OEM spec. Replacing both inlet and outlet sensors is recommended on high-hour machines.

  5. Clear fault codes

    Use a diagnostic scanner to clear the fault code from the Engine Control Module (ECM).

  6. Verify SCR system operation

    Perform a forced regeneration or operate the machine under load to allow the ECM to verify the repair and confirm temperature readings are back within the plausible range.

Parts you might need

(4)
  • Fits FR, CX, T7, T8 models

  • Sensor84574743

    Fits New Holland T8 Series and Case IH Magnum models

  • TEMP.SENSOR

    8900123435

    Generic CNH New Holland temperature sensor

  • SCR Temperature Sensor (Inlet or Outlet)

    Generic part name; verify exact part number with dealer based on serial number

Get help to fix this fault by requesting a quote

Browse other New Holland codes