3594

New Holland 3594 – ECU: Torque Limitation Due to Selective Catalytic Reduction (SCR)

Issue description

The engine control unit (ECU) is actively reducing the engine's torque and power output as a protective measure due to a detected malfunction within the Selective Catalytic Reduction (SCR) emissions control system. This derate condition prevents excessive emissions and potential damage to the after-treatment components, and will likely be accompanied by a dashboard warning light.

Applies to these machines

  • T6 Series
  • T7 Series
  • T8 Series
  • T9 Series

Check the cause

  1. Check DEF level and quality using a refractometer to ensure urea concentration is approximately 32.5% and free of contamination

  2. Scan for other active SCR-related fault codes (e.g., NOx sensors, DEF pump pressure, DEF tank temperature) to pinpoint the root cause

  3. Visually inspect the DEF injector nozzle, DEF lines, and tank opening for white, crusty crystallization deposits that can block flow

  4. Inspect electrical wiring and connectors for the DEF pump, NOx sensors, and SCR control module for corrosion, damage, or loose connections

Repair steps

  1. Address other active fault codes

    Diagnose and repair any other active SCR-related fault codes first, such as replacing a faulty NOx sensor, as code 3594 is often a secondary derate code.

  2. Clean DEF crystallization

    Gently remove any white, crusty deposits found. Flush components like the DEF injector with deionized water. Do not use harsh chemicals.

  3. Replace the DEF filter

    Replace the inline DEF filter, which is a serviceable component that can become clogged.

  4. Test and replace DEF pump/dosing module

    Use a diagnostic tool to actuate the DEF pump. If faulty, replace the module. Note that a new DEF module will likely require programming to the vehicle.

  5. Test and replace NOx sensors

    Use a diagnostic tool to monitor readings from the upstream and downstream NOx sensors. Replace if they are not functioning correctly.

  6. Clear codes and verify system

    Clear all fault codes using a diagnostic tool. Perform a system verification or 'startups counter restart' (using tools like Jaltest) to reset the engine derate and restore power.

Parts you might need

(6)
  • Manufacturer: Bosch. Fits wide range including T6 and T7 series. May require programming.

  • DEF Dosing Module/Pump (Remanufactured)

    5802513624R

    Manufacturer: Bosch. Listed for T9.645 tractor. May require programming.

  • DEF Tank

    51582964

    Replaces 84277926 for T8.360

  • DEF Tank Sender Unit

    84171379

    For T8.360

  • For T9.450

  • DEF Filter84254852

    Fits various CR, CX, FR, LM, and T6-T9 series models

Get help to fix this fault by requesting a quote

Browse other New Holland codes