3611

New Holland 3611 – ECM: Catalytic Converter Efficiency Below Threshold

Issue description

The Selective Catalytic Reduction (SCR) system's efficiency in converting Nitrogen Oxides (NOx) is below the first predetermined threshold. The Engine Control Module (ECM) continuously monitors the after-treatment system by comparing readings from the upstream and downstream NOx sensors. When the downstream sensor reports higher than expected NOx levels, it indicates the catalytic converter is not reducing nitrogen oxides to the expected level. This condition will likely trigger a warning on the operator's display and may cause the engine to enter a derated or limp mode to limit emissions.

Applies to these machines

  • T6
  • T7
  • T8
  • T9
  • FR
  • CX

Check the cause

  1. Check DEF (AdBlue) quality using a refractometer to ensure the urea concentration is at the correct level (typically 32.5%) - this is the most common cause of SCR faults

  2. Inspect the exhaust system for any air leaks between the upstream and downstream NOx sensors, which can skew sensor readings

  3. Visually inspect the upstream and downstream NOx sensors and their wiring harnesses for signs of corrosion, damage, or loose connections, especially near hot exhaust components

  4. Review other active or stored fault codes related to the DEF dosing system, temperature sensors, or EGR system, as these can negatively impact SCR efficiency and must be addressed first

  5. Utilize the New Holland Electronic Service Tool (EST) to monitor live data from the NOx sensors and check for software updates

Repair steps

  1. Confirm the fault

    Using a diagnostic tool, confirm that 3611 (or DTC 21E) is an active fault. Note any other active codes.

  2. Test and replace DEF

    Draw a sample of the DEF and test its concentration. If the quality is poor or unknown, drain the tank, flush with distilled water if necessary, and refill with fresh, ISO-certified DEF. Clear the codes and operate the machine to see if the fault returns.

  3. Inspect and test NOx sensors

    If the fault persists, use the New Holland EST software to compare live data readings from the upstream and downstream sensors. A downstream sensor that mirrors the readings of the upstream sensor, or a sensor with stuck readings, is likely faulty and should be replaced.

  4. Check for exhaust leaks

    If sensor readings are inconclusive, perform a thorough physical inspection of the exhaust system for leaks between the turbo and the downstream NOx sensor.

  5. Perform SCR efficiency test

    If available in the diagnostic software, run a manual SCR efficiency test to command the system to operate under specific conditions and verify the catalyst's performance.

  6. Replace faulty components

    If a NOx sensor is identified as faulty, replace it. If all other components (DEF, sensors, wiring) are confirmed to be in good working order and the fault persists, the SCR catalyst itself is likely degraded or contaminated and should be replaced as a final step.

  7. Clear codes and verify repair

    After replacing any components, clear the fault codes using a diagnostic tool and operate the machine under various loads to ensure the repair is successful and the fault does not return.

Parts you might need

(3)
  • Can serve as either the upstream or downstream sensor. Fits New Holland FR, CX, T7, and T8 series machines.

  • Exhaust System Catalyst

    Replacement of the catalyst assembly should be considered the last resort. Verify the specific OEM part number through an official dealer parts catalog using the machine's serial number.

  • AdBlue DEF Filter

    Regular replacement is part of standard maintenance to prevent contamination. Available for T6, T7, T8, and T9 series tractors.

Get help to fix this fault by requesting a quote

Browse other New Holland codes