3648

New Holland 3648 – ECU: EVGT Boost Pressure Overpressure Control

Issue description

The Engine Control Unit (ECU) has detected an overpressure condition from the Electronic Variable Geometry Turbocharger (EVGT). The boost pressure produced by the turbocharger is significantly higher than the level commanded by the engine controller. This condition can lead to engine power loss, the engine entering a derated 'limp mode', or potential damage to the engine and turbocharger if left unaddressed.

Applies to these machines

  • T7.170
  • T7.185
  • T7.200
  • T7.210
  • T7.220
  • T7.230
  • T7.235
  • T7.245
  • T7.250
  • T7.260
  • T7.270
  • T7.290
  • T7.315
  • T6 Series
  • T8 Series
  • T9 Series

Check the cause

  1. Check for other active or stored fault codes using a diagnostic scan tool (codes like 3019 or 3022 can provide further diagnostic clues).

  2. Inspect the air intake and charge air system thoroughly for leaks, cracks, loose connections, or a clogged air filter.

  3. Visually inspect the EVGT actuator and linkage for physical damage, sticking, or obstruction. The actuator should move freely. Remove the actuator and manually check if the sector gear on the turbocharger moves smoothly from stop to stop.

  4. Inspect the boost pressure sensor for physical damage and check its intake manifold mounting port for soot clogging.

  5. Test the boost pressure sensor electrically: check for approximately 5V at the supply pin (key on, engine off) and around 1V at the signal wire at idle. The voltage should increase with engine RPM. A fixed voltage or erratic readings suggest a faulty sensor.

  6. Compare the boost pressure (MAP) sensor reading with the atmospheric pressure (BARO) sensor reading using a scan tool (key on, engine off). They should be nearly identical.

Repair steps

  1. Address leaks and restrictions

    If any leaks in the charge air system or restrictions in the intake were found, repair them first. Clear the fault codes and operate the machine to see if the code returns.

  2. Clean the boost sensor port

    If the sensor port was found to be clogged with soot, clean it thoroughly. Reinstall the sensor, clear the codes, and re-test.

  3. Replace the boost pressure sensor

    If diagnostic tests indicate the boost pressure sensor is faulty (e.g., incorrect voltage readings, or fails the key-on-engine-off pressure comparison), replace it and clear the fault codes.

  4. Test the EVGT actuator

    Use specialized diagnostic tools to run a VGT function test to sweep the actuator and check its range of motion. If the actuator fails the function test when disconnected from the turbo, replace the actuator.

  5. Replace the turbocharger assembly

    If the actuator passes its independent function test, but the vanes still do not move correctly when it is attached, this indicates a mechanical problem within the turbocharger itself (e.g., stuck vanes). Replace the entire turbocharger assembly.

Parts you might need

(20)
  • OEM Bosch. Cross-reference by serial number.

  • Replaces 87678028.

  • Boost Pressure Sensor

    87678028

    Replaced by 84407732.

  • Bosch cross-reference 0281006102, 0281002576.

  • Boost Pressure Sensor

    0281006102

    Bosch cross-reference for 504372225.

  • Boost Pressure Sensor

    0281002576

    Bosch cross-reference for 504372225.

  • Boost Pressure Sensor

    QTP-400255

    Aftermarket option.

  • OEM Holset. Replaces 84342159. Requires new gaskets and hardware.

  • Replaced by 504369121.

  • Turbocharger Assembly (EVGT) - Remanufactured

    504369121R

    Remanufactured option.

  • Turbocharger Assembly (EVGT) - Remanufactured

    84342159R

    Remanufactured option.

  • Turbocharger Assembly (EVGT)

    QTP-400325

    Aftermarket option.

  • Boost Pressure Sensor / MAP Sensor

    504307953

    OEM part. Often includes an integrated air temperature sensor. Fits T6, T7, T8, and T9 series tractors with FPT engines.

  • OEM part. Often includes an integrated air temperature sensor. Fits T6, T7, T8, and T9 series tractors with FPT engines.

  • Boost Pressure Sensor / MAP Sensor

    504073323

    Case/New Holland OEM number replaced by common aftermarket sensor.

  • Boost Pressure Sensor / MAP Sensor

    5802231983

    Case/New Holland OEM number replaced by common aftermarket sensor.

  • EVGT Turbocharger (Complete Assembly)

    3787091

    OEM part for T8.390 with FPT Cursor 9. Includes variable geometry mechanism.

  • EVGT Turbocharger (Complete Assembly)

    87840271

    OEM part. Includes variable geometry mechanism.

  • EVGT Turbocharger (Complete Assembly)

    81876813

    OEM part for 8970/8970A. Includes variable geometry mechanism.

  • EVGT Turbocharger (Complete Assembly)

    841805-5006S

    Aftermarket part for T8 with FPT Cursor 9 8.7L. Includes variable geometry mechanism.

Get help to fix this fault by requesting a quote

Browse other New Holland codes