3651

New Holland 3651 – ECU: Battery Voltage Uncorrect

Issue description

The Engine Control Unit (ECU) has detected an issue with the electrical system voltage. The voltage is either too high, too low, or the signal from the battery voltage sensor is erratic. This indicates a potential failure in the battery, alternator, or the connecting wiring harness.

Applies to these machines

  • Skid Steer Loaders (SSL) with F5C engine
  • Compact Track Loaders (CTL) with F5C engine

Check the cause

  1. Visually inspect battery terminals for corrosion and ensure all cable connections to the battery, alternator, and chassis ground are clean and tight

  2. Inspect the wiring harness between the battery, alternator, and ECU for chafing, burns, or rodent damage

  3. Perform a static battery voltage test with the engine off (a healthy battery should read 12.4 to 12.7 volts)

  4. Perform a cranking voltage test while starting the engine (voltage should not drop below 9.6 volts)

  5. Test charging voltage at idle (should read 13.8 to 14.5 volts across battery terminals)

  6. Test charging voltage under load at 1,500 RPM with electrical accessories turned on (voltage should remain above 13.5 volts)

Repair steps

  1. Clean and tighten connections

    Clean any white or green corrosive deposits from the battery terminals with a wire brush. Tighten any loose connections at the battery, alternator, and main ground strap.

  2. Charge or replace battery

    If the battery fails the static voltage test (<12.4V) or cranking test (<9.6V), fully charge it and re-test. If it still fails to hold a charge, replace the battery.

  3. Repair or replace wiring harness

    If physical damage is found on the wiring harness between the battery, alternator, and ECU, repair the affected wires. If damage is extensive, utilize a harness repair service or replace the harness entirely.

  4. Replace alternator

    If the charging tests show no charge (voltage remains around 12.6V while running), overcharging (voltage >14.8V), or rhythmically fluctuating voltage, the alternator or its internal voltage regulator is faulty and the alternator assembly must be replaced. Ensure the alternator belt is in good condition and properly tensioned during installation.

  5. Clear fault codes

    After completing the repairs, clear the fault codes using an Electronic Service Tool (EST) or by disconnecting the battery for a few minutes.

  6. Verify the repair

    Start the engine and re-run the charging system tests to ensure the voltage is within the correct range and that the fault code does not reappear.

Parts you might need

(6)
  • 12V 675 CCA Wet Battery

    F795DSW

    Standard replacement battery

  • Premium Heavy-Duty SmartStart Battery

    F885DSW

    Heavy-duty battery option

  • Remanufactured Alternator

    504060771R

    Fits various engines including F5HFL463A used in some SSL models

  • AlternatorSBA185046320

    Aftermarket replacement alternator for some tractors and skid steers

  • Alternator

    86520116

    Remanufactured option available as 86520116R

  • Wiring Harness

    Specific part numbers depend on machine model; CNH offers a wire harness repair program for older or hard-to-find harnesses

Get help to fix this fault by requesting a quote

Browse other New Holland codes