3661

New Holland 3661 – EDC: EGR Governor Deviation Negation Error

Issue description

This code indicates that the engine's control system has detected a negative deviation in the Exhaust Gas Recirculation (EGR) valve's position. The actual physical position of the EGR valve is less than the position commanded by the engine control unit. This is typically caused by mechanical binding due to heavy carbon or soot buildup, a failing internal position sensor within the valve, or a wiring issue preventing the valve motor from achieving the target position.

Applies to these machines

  • T4.55
  • T4.65
  • T4.75
  • T4.80
  • T4.90
  • T4.100
  • T4.105
  • T6 Series
  • T7 Series
  • L221
  • L223
  • L228
  • L230
  • L321
  • L328
  • C227
  • C232
  • C237
  • C238
  • C327
  • C332
  • C337
  • B90B
  • B100C
  • B110C
  • B115C
  • W170B
  • W190B
  • E70BSR
  • E80BMSR

Check the cause

  1. Verify system voltage: Ensure the battery is fully charged and the alternator is outputting correct voltage. Low battery voltage can disable the power stage diagnosis for the EGR (often triggering a related code 3660).

  2. Inspect the electrical harness and connector at the EGR valve for corrosion, bent pins, or wire chafing that could cause an open circuit or high resistance.

  3. Use a diagnostic service tool (such as CNH E.A.S.Y.) to perform an active command test of the EGR valve, monitoring commanded versus actual position to confirm the deviation.

  4. Remove the EGR valve and perform a mechanical inspection for excessive soot or carbon buildup that could physically jam the valve flap.

Repair steps

  1. Disconnect battery

    Turn off the machine, remove the key, and disconnect the negative battery cable.

  2. Remove EGR valve

    Locate the EGR valve assembly on the engine's exhaust/intake manifold. Disconnect the electrical harness connector. Remove the mounting bolts securing the EGR valve to the manifold and/or EGR cooler piping. Remove the valve and discard the old metal gaskets.

  3. Clean mating surfaces

    Thoroughly clean the mating surfaces on the manifold. Caution: Ensure no carbon chunks or gasket debris fall into the intake or exhaust ports.

  4. Install new EGR valve

    Install the new EGR valve using new gaskets. Torque the mounting bolts to the OEM specifications for your specific engine model.

  5. Reconnect components

    Reconnect the electrical harness to the new valve, then reconnect the negative battery cable.

  6. Calibrate EGR valve

    Connect your diagnostic service tool, clear the 3661 fault code, and perform the EGR valve learning/calibration procedure. This step is critical as it allows the EDC to learn the new valve's minimum and maximum end stops.

Parts you might need

(2)

Get help to fix this fault by requesting a quote

Browse other New Holland codes