New Holland 3690 – Engine ECU: Glow Module Error in GCU-T
Issue description
This code indicates a malfunction or communication failure involving the Glow Control Unit (GCU-T), which is the electronic module responsible for managing the engine's glow plug preheating system during cold starts. The Engine ECU monitors this module and logs the fault when it detects an error.
Applies to these machines
18 machines- Workmaster series (50 through 120)
- PowerStar / T4 series (T4.55 to T4.115)
- T5 series (T5.75 to T5.120)
- TD5 series
- Boomer 46D
- Boomer 54D
- L225
- L230
- C232
- C238
- SR series
- SV series
- TR series
- W50C
- W60C
- W70C
- B95C
- B110C
Check the cause
Verify the code using an Electronic Service Tool to check if the fault is currently active, then clear it and operate the machine to see if it returns.
Inspect the wiring harness and connectors between the Engine ECU and the GCU-T for physical damage, chafing, or corrosion. Disconnect the module and inspect the connector pins.
Measure the resistance of the wiring harness to ensure there are no open circuits, short circuits to ground, or short circuits to the battery, wiggling the harness to reveal intermittent issues.
Verify that the GCU-T is receiving its nominal 12V power supply.
Repair steps
Turn off power
Turn the key switch to the OFF position.
Disconnect module
Disconnect the wiring harness from the Glow Plug Control Module (GCU-T).
Repair wiring
If diagnostic testing reveals a short or open circuit in the wiring harness, repair or replace the affected harness section.
Replace GCU-T
If the wiring harness, power supply, and grounds test within specification, the GCU-T itself has failed internally and must be replaced. Remove the mounting hardware securing the old GCU-T and install the new module.
Reconnect and verify
Reconnect the wiring harness, ensuring the connector is fully seated and locked. Use the Electronic Service Tool to clear the fault codes, then start the engine to confirm the elimination of the fault and verify that the cold-start preheating system operates correctly.
Parts you might need
(1)Get help to fix this fault by requesting a quote