3702

New Holland 3702 – ECU: Failed Engine Start Detected

Issue description

The engine's electronic control module (ECM) has detected a failure during the engine start-up sequence, indicating that the engine is cranking but not firing up as expected. This code is a general indicator of a starting problem and is often a consequence of another underlying issue, such as low fuel pressure or sensor failures, requiring further investigation to identify the root cause.

Applies to these machines

  • T3 Series
  • T4 Series
  • T6.120
  • T6.140
  • T6.150
  • T6.155
  • T6.160
  • T6.165
  • T6.175
  • T7.170
  • T7.185
  • T7.200
  • T7.210
  • T7.220
  • T7.235
  • T7.250
  • T7.260
  • T7.270
  • T6020
  • T6030
  • T6040
  • T6050
  • T6070
  • T7030
  • T7040
  • T7050
  • T7060
  • Backhoes
  • Loaders
  • Telehandlers

Check the cause

  1. Check fuel tank and ventilation to ensure there is sufficient, high-quality fuel and that the tank vent is not blocked (which could create a vacuum)

  2. Inspect for air in the fuel system by visually checking for bubbles in the fuel lines (a clear test line can be installed to observe flow)

  3. Inspect for fuel inlet or return restrictions, such as clogged fuel filters, pre-filters, blockages, or kinked lines

  4. Inspect electrical connections and wiring to the fuel pump, rail pressure sensor, and injectors for damage, corrosion, or loose connections

  5. Verify fuel supply pump performance by testing the fuel lift pump for adequate pressure delivery to the high-pressure pump

Repair steps

  1. Address basic issues

    Confirm the battery is fully charged and all safety interlocks are functioning correctly before proceeding to fuel system repairs.

  2. Bleed the fuel system

    If air is suspected or found in the fuel system, bleed the system according to the operator's manual to remove all trapped air.

  3. Replace fuel filters

    Replace the main fuel filter and any pre-filters as a primary step to address potential fuel restrictions.

  4. Test and replace fuel lift pump

    If fuel pressure is low, test the fuel lift pump. Replace the pump if it fails to produce the specified pressure.

  5. Inspect and test fuel rail pressure sensor

    Test the rail pressure sensor, as a faulty sensor can send incorrect data to the ECU and prevent starting. Replace if necessary.

  6. Check high-pressure fuel system

    If the low-pressure side is functioning correctly, check the minimum rail pressure during cranking. Diagnostics on the high-pressure pump and injectors may require specialized tools and an authorized dealer.

Parts you might need

(20)
  • Fuel Rail Pressure Sensor

    73379120

    Commonly fits T6 and T7 series. Alternate OEM numbers: 504333094, 0281002930

  • Fits a wide range of T6, T7, T6000, and T7000 series tractors, combines, and construction equipment

  • Interchanges with 504380241, 84268475, 4757882, 504090936, 87473339, 84130988. Critical to match part number to specific model

  • Generic Sensor5801474160

    Unspecified sensor for reference

  • Common on Iveco 6.7L engines used in New Holland T6/T7 tractors and CR combines.

  • Common on Iveco 6.7L engines used in New Holland T6/T7 tractors and CR combines.

  • Common on Iveco 6.7L engines used in New Holland T6/T7 tractors and CR combines.

  • Fuel Rail Pressure Sensor

    0281002930

    Bosch Part #

  • Fuel Rail Pressure Sensor

    0281006199

    Bosch Part #

  • Fits various T-series tractors (T4, T5, T6, T7) and combines.

  • Fits various T-series tractors (T4, T5, T6, T7) and combines.

  • Fits various T-series tractors (T4, T5, T6, T7) and combines.

  • Fits various T-series tractors (T4, T5, T6, T7) and combines.

  • Starter Motor (Remanufactured)

    51661114R

    Fits some T3, T4, and Workmaster models

  • Starter Motor

    SBA185086750

    Verify fitment by serial number

  • Fits various Boomer, Workmaster, and Farmall models

  • Starter Motor

    500338952

    Fits various TL and TN series tractors

  • Ignition SwitchSBA385202601

    Example for T1110 Compact Tractor

  • Fuel Injector (Remanufactured)

    504164563R

    For some T4.65, T4.75 models

  • High-Pressure Common Rail Fuel Kit (Remanufactured)

    92274986R

    Example for L328 Skid Steer, includes pump, injectors, rail, and lines

Get help to fix this fault by requesting a quote

Browse other New Holland codes