3779

New Holland 3779 – EDC: Diesel particulate filter (DPF): Diagnostic fault check for particulate filter efficiency

Issue description

The engine control system has detected that the DPF is no longer effectively trapping soot and particulate matter. The system calculates DPF efficiency by monitoring the exhaust gas temperatures and the differential pressure across the filter. If the pressure drop across the DPF is significantly lower than what the computer expects for the calculated soot load, it indicates that exhaust gases are passing through without being filtered—usually pointing to a cracked, melted, or compromised filter substrate, or a failure in the sensor reading that pressure.

Applies to these machines

  • T4
  • T5
  • T6
  • T7
  • T8
  • T9
  • TD5
  • L213
  • L215
  • L216
  • L316
  • Excavators
  • Wheel Loaders

Check the cause

  1. Visual Inspection of the Exhaust System: Check for any exhaust leaks upstream of the DPF or between the engine and the DPF. An exhaust leak will lower the pressure reaching the DPF, tricking the sensors into thinking the filter has low efficiency.

  2. Inspect Differential Pressure Sensor Lines: Check the metal pipes and rubber hoses connecting the DPF to the differential pressure sensor. Look for cracks, melting, loose fittings, or blockages caused by soot buildup or ice.

  3. Test Sensors via Diagnostic Tool: Connect the CNH E.A.S.Y. diagnostic tool. Verify the live data for the DPF differential pressure sensor and Exhaust Gas Temperature (EGT) sensors. The pressure sensor should read zero at key-on/engine-off.

  4. Check for Cascading Codes: Look for related codes that might have caused the failure, such as 3782 (regeneration too frequent) or 3780 (engine protection active due to DPF).

Repair steps

  1. Resolve Sensor/Line Issues

    If the differential pressure sensor lines are blocked, clean them out with compressed air (disconnected from the sensor). If the hoses are damaged, replace them. If the sensor fails electrical testing or reads out of range, replace the sensor.

  2. Perform a Forced Regeneration

    If the sensors and lines are intact, use the CNH E.A.S.Y. diagnostic tool to initiate a forced stationary regeneration. This attempts to burn off accumulated soot and allows the ECU to recalculate the efficiency baseline.

  3. Inspect the DPF Substrate

    If the forced regeneration fails, or if the 3779 code returns immediately under load, the DPF substrate is likely physically damaged (cracked or melted). Remove the DPF assembly from the exhaust stream and visually inspect the honeycomb substrate for cracks, melting, or heavy ash face-plugging.

  4. Replace the DPF

    If the substrate is compromised, install a new or remanufactured DPF assembly. Ensure all gaskets and V-band clamps are properly seated and torqued to OEM specifications to prevent future exhaust leaks.

  5. Reset ECU Values

    After replacing the DPF, you must use the diagnostic tool to command a "DPF Replacement" reset in the Engine ECU. This resets the calculated ash and soot load values back to zero. Clear the 3779 fault code and test run the machine under load to verify the repair.

Parts you might need

(4)

Get help to fix this fault by requesting a quote

Browse other New Holland codes