3780

New Holland 3780 – ECU: Engine Protection: Engine protection active due to particulate filter

Issue description

This code indicates that the Diesel Particulate Filter (DPF) has become severely restricted or clogged with soot or ash, or has failed to regenerate properly. As a result, the system has triggered an engine derate or protection mode to prevent catastrophic damage to the engine and exhaust aftertreatment system.

Applies to these machines

  • T4
  • T5
  • T6
  • T7
  • T8
  • Boomer
  • Workmaster
  • L213
  • L215
  • L216
  • L228
  • L316
  • Excavators
  • Combines

Check the cause

  1. Check for accompanying DPF-related codes (e.g., 3781, 3782, 3783, 3784) that provide more context.

  2. Use the CNH E.A.S.Y. diagnostic tool (or compatible scanner) to read the current soot mass/load in the DPF.

  3. Inspect the DPF differential pressure sensor and its connecting tubes for blockages, melting, or damage, which can falsely trigger a clogged filter code.

  4. Check for upstream issues such as intake air leaks, boost leaks, or fuel injector issues causing excessive black smoke (soot) that prematurely clogs the DPF.

Repair steps

  1. Attempt a forced regeneration

    Connect the CNH E.A.S.Y. diagnostic tool. If the soot level is high but has not exceeded the critical lockout threshold, initiate a forced stationary regeneration.

  2. Address locked regenerations

    If codes 3783 or 3784 are present, the ECU has locked out regeneration for safety to prevent a fire. Do not attempt to bypass this without inspecting the filter.

  3. Remove the DPF

    If the filter cannot be regenerated or is packed with ash (which cannot be burned off), remove the DPF assembly from the exhaust system.

  4. Clean or replace DPF

    Have the DPF professionally cleaned (baked and blown out in a specialized machine) or replace it with a new or Remanufactured (Reman) unit.

  5. Replace gaskets and sensors

    Whenever reinstalling the DPF, replace all sealing rings and gaskets to prevent exhaust leaks. If the differential pressure sensor was reading erratically, replace it.

  6. Reset the ECU

    Use the diagnostic tool to perform a 'DPF Soot Level Reset' and clear the DTCs (Error Code Eraser function). The engine must know it has a clean filter to resume normal fuel mapping and regeneration schedules.

Parts you might need

(8)

Get help to fix this fault by requesting a quote

Browse other New Holland codes