3802

New Holland 3802 – ECU: Turbine Upstream Pressure Sensor SRC Low

Issue description

The Engine Control Module (ECM) has detected an abnormally low signal (Signal Range Check low) from the turbine upstream pressure sensor. This sensor, located before the turbocharger turbine, measures the pressure of exhaust gases entering the turbine. A low or missing signal prevents the ECM from properly managing engine performance, regulating turbocharger boost, and controlling fuel delivery. This condition can result in the engine entering Limp Mode, hard starting, misfiring, hesitation, and decreased fuel efficiency.

Applies to these machines

  • T6.145
  • T6.155
  • T6.160
  • T6.165
  • T6.175
  • T6.180
  • T7.165S
  • T7.175
  • T7.190
  • T7.210
  • T7.225
  • T7.230
  • T7.245
  • T7.260
  • T7.270
  • T7.290
  • T7.315
  • T8.320
  • T8.350
  • T8.380
  • T8.410
  • T8.435
  • WORKMASTER 120
  • L218
  • L220

Check the cause

  1. Visually inspect the wiring harness and connectors leading to the turbine upstream pressure sensor for damage, chafing, corrosion, or loose connections

  2. Check for related active fault codes, such as sensor supply voltage faults (codes 520194-03 or 520194-04), which indicate a power supply issue rather than a sensor failure

  3. Determine if the fault is currently active. If it is intermittent, the issue may be harder to pinpoint.

  4. Test the sensor's signal and circuit integrity using a multimeter to check for correct voltage and continuity according to the service manual

Repair steps

  1. Safety First

    Ensure the machine is on level ground, the parking brake is engaged, all attachments are lowered, the engine is off, and the key is removed.

  2. Locate the Sensor

    The turbine upstream pressure sensor is located on the exhaust system, before the turbocharger.

  3. Disconnect the Sensor

    Carefully disconnect the electrical connector from the sensor.

  4. Remove the Old Sensor

    Using the appropriate wrench, unscrew and remove the old sensor from its mounting point.

  5. Install the New Sensor

    Screw the new sensor into place and tighten it to the manufacturer's specified torque.

  6. Reconnect the Sensor

    Reconnect the electrical connector to the new sensor.

  7. Clear Fault Codes

    Use a diagnostic tool to clear the fault code from the ECU's memory.

  8. Verify the Repair

    Start the engine and check if the fault code reappears.

Parts you might need

(5)
  • Listed for WORKMASTER 120 (Tier 4B)

  • Listed for T6, T7, T8 series. Cross-references to 504388711 and 5802280208. Note: Catalog may describe this as 'Engine Oil Filter Pressure Sensor', verify with dealer.

  • OEM CNH/FPT part. Fits FPT/NEF 3.4L, 4.5L, 6.7L, and Cursor Tier 4 / Stage V engines. Cross-references include 84385192, 87312193, and 47128360.

  • Common CNH part number for F5C/F5H engines. Always verify the exact part number against the machine's specific PIN/serial number.

  • Turbine Upstream Pressure Sensor / Exhaust Gas Pressure Sensor

    55241075

    Common CNH part number for F5C/F5H engines. Always verify the exact part number against the machine's specific PIN/serial number.

Get help to fix this fault by requesting a quote

Browse other New Holland codes