3834

New Holland 3834 – ECU: Throttle Valve Actuator SRC High

Issue description

The Engine Control Unit (ECU) has detected an 'SRC High' (Short Road to Circuit High) condition in the power supply circuit for the electronic throttle valve actuator. This indicates that the circuit is receiving excessively high voltage, which is typically caused by a short to a positive voltage source in the wiring harness or an internal electrical failure within the throttle valve actuator component itself.

Applies to these machines

  • T4.55
  • T4.65
  • T4.75
  • T4.85
  • T4.95
  • T4.105
  • T4.115
  • T4S.55
  • T4S.65
  • T4S.75
  • T5.75
  • T5.85
  • T5.95
  • T5.105
  • T5.115
  • B90B
  • B95B
  • B100C
  • B110C
  • L221
  • L228
  • L230
  • C232
  • C238
  • Farmall 55A
  • Farmall 115A
  • Farmall 55C
  • Farmall 115C
  • 580N
  • 580 Super N
  • TR310
  • TV370

Check the cause

  1. Visually inspect the wiring harness leading to the electronic throttle valve actuator for chafing, melting, or pinched wires, paying special attention to routing on top of and down the side of the engine.

  2. Disconnect and inspect the electrical connectors at both the throttle valve actuator and the ECU for corrosion, moisture ingress, or damaged pins.

  3. With the key on and the actuator unplugged, use a multimeter to test the signal and control wires in the harness connector for unexpected voltage (indicating a short to power).

  4. Verify correct voltage on the power supply wire (typically 5V or 12V) and confirm a good ground connection.

  5. Measure internal resistance between the motor pins on the actuator to check for an internal short (if wiring harness tests normal, the fault is likely internal to the actuator).

Repair steps

  1. Prepare machine

    Park the machine on a level surface, engage the parking brake, and disconnect the battery before beginning any electrical repair work.

  2. Remove faulty actuator

    Locate the electronic throttle valve assembly on the intake manifold interface. Disconnect the electrical connector, loosen, and remove the mounting bolts.

  3. Clean mounting surface

    Thoroughly clean the mating surface on the intake manifold to ensure a proper seal before installing the new part.

  4. Install new actuator

    Install the new electronic throttle valve assembly and tighten the fixing bolts to the manufacturer's specified torque.

  5. Test and clear codes

    Reconnect the electrical connector and the battery. Turn the ignition on, clear the fault codes using a diagnostic tool, and start the engine to verify the fault does not return.

  6. Perform calibration

    Use a capable diagnostic tool to run a throttle valve calibration or 'learn' procedure, allowing the ECU to learn the new part's position and range.

Parts you might need

(15)
  • Cross-reference part numbers: 5801445778, 5801831821. Assembly includes butterfly valve, integrated electric servo motor, and position sensor. It is a single, non-serviceable unit.

  • Throttle Valve Actuator (TVA) / Valve Throttle

    504385542

    F5C Engines / General Tier 4. Ensure you match the part number to the specific engine serial number, as FPT engines utilize different throttle bodies depending on the emissions tier.

  • Throttle Valve Actuator (TVA) / Valve Throttle

    SBA125906010

    Specific Skid Steers like L218/L220. Ensure you match the part number to the specific engine serial number, as FPT engines utilize different throttle bodies depending on the emissions tier.

  • Electronic Throttle Control / Throttle Valve Actuator

    84408228

    Genuine CNH part used across various New Holland and Case models. Verify fitment with dealer using machine serial number.

  • Manufacturer: Holdwell (Aftermarket). Listed as a replacement for New Holland.

  • Actuator Throttle Motor (Aftermarket)

    84036177

    Manufacturer: Holdwell (Aftermarket). Listed as a replacement for New Holland.

  • Manufacturer: New Holland. Genuine OEM part.

  • Manufacturer: New Holland. Monitors the throttle valve's position; a faulty sensor can cause related issues.

  • Throttle Control

    87528964

    Fits various Compact Wheel Loaders, Loader Backhoes, and Loader Tractors

  • Throttle (includes pedal and sensor)

    84374768

    Fits various Compact Track Loaders and Skid Steer Loaders

  • Fits WORKMASTER 75 Tractor

  • Throttle Valve

    72108330

    Verify fitment by serial number

  • Foot Throttle with Sensor

    47414005

    Case OEM part. Fits various Case and New Holland skid steers and compact track loaders.

  • Throttle Control

    47409019

    New Holland OEM part. Listed for New Holland Compact Track Loaders.

  • Throttle Control Ball Joint

    275064

    New Holland OEM part. Fits various New Holland skid steer and compact track loaders.

Get help to fix this fault by requesting a quote

Browse other New Holland codes