3855

New Holland 3855 – EDC: Lambda sensor: Oxygen concentration implausibly low in part load operation

Issue description

The engine control system has detected that the oxygen concentration in the exhaust gas is lower than expected when the engine is operating under a partial load. This typically indicates a rich air-to-fuel mixture caused by too much fuel or insufficient air, or a skewed reading from a faulty Lambda (oxygen) sensor itself.

Applies to these machines

  • T4 series
  • T5 series
  • T6 series
  • T7 series
  • T4.100
  • T6.145
  • T7.270
  • Speedrower 130
  • Speedrower 160
  • Speedrower 200
  • Speedrower 220
  • Speedrower 240
  • Speedrower 260
  • LM series
  • TH series
  • LM6.32
  • TH7.42
  • B95C
  • L230
  • C238

Check the cause

  1. Inspect the fault wires and sensor connectors for the Lambda sensor for short circuits, open circuits, or corrosion

  2. Check for leaking fuel injectors, which can dump excess fuel into the cylinder and deplete exhaust oxygen

  3. Check for air ingress into the fuel supply, fuel inlet/return restrictions, and verify the fuel delivery performance of the lift pump and high-pressure pump

  4. Inspect the intake manifold and exhaust system for leaks that could skew the air-fuel ratio or the sensor's readings

Repair steps

  1. Verify the code

    Connect a CNH diagnostic tool (e.g., E.A.S.Y.) to verify that code 3855 is active and monitor the live data for the Lambda sensor.

  2. Inspect the harness

    Trace the wiring harness from the Lambda sensor to the EDC. Repair any damaged, melted, or chafed wires.

  3. Perform mechanical checks

    If the wiring is intact, perform the fuel pressure and injector leak-down tests to rule out mechanical issues causing a rich condition.

  4. Replace the sensor

    If no mechanical fuel/air issues are found and the wiring is good, the Lambda sensor is internally faulty or fouled and must be replaced.

  5. Install new sensor

    Remove the old Lambda sensor from the exhaust stream. Install the new sensor (ensure the threads are treated with high-temp anti-seize if not pre-greased from the factory) and torque to OEM specifications.

  6. Clear and test

    Clear the fault codes using the diagnostic tool. Run the machine under part-load conditions to ensure the code does not return and the sensor reads within normal parameters.

Parts you might need

(3)

Get help to fix this fault by requesting a quote

Browse other New Holland codes