3928

New Holland 3928 – Engine Control Unit (ECU) / EDC (Electronic Diesel Control): Fuel pressure control Metering unit: Exceeding of a maximum peak pressure at empty fuel tank.

Issue description

This code indicates that the fuel rail pressure has exceeded the maximum allowable limit while the system is under the control of the fuel metering unit (MeUn), specifically triggered when the system detects or assumes an empty fuel tank condition.

Applies to these machines

  • T4
  • T5
  • T6
  • T7
  • T8
  • C232
  • C238
  • L225
  • L230
  • CR series

Check the cause

  1. Verify the fuel tank is not actually empty and inspect the bottom and sidewalls of the fuel tank for debris.

  2. Install a clear test line at the inlet of the high-pressure pump to observe for air entering the system (large amounts of air indicate a leak).

  3. Test the low-pressure fuel supply between the filter and the high-pressure pump (should be a minimum of 5 bar/72 psi; a drop below 0.276 bar/4.0 psi indicates a severe restriction).

  4. Inspect the fuel pre-filter, primary fuel filters, and Voss O-ring fittings for blockages, damage, or air leaks.

Repair steps

  1. Resolve Supply Issues

    If the diagnostic checks reveal air in the system or low supply pressure, replace the fuel filters and repair any leaking Voss fittings or fuel lines. Bleed the fuel system.

  2. Test the Fuel Metering Unit (MeUn)

    Check the wiring harness for continuity and proper voltage to the pulse-width modulated (PWM) solenoid valve that regulates fuel supply at the inlet of the high-pressure pump.

  3. Replace the Fuel Metering Unit

    If the wiring is intact but the pump continues to over-pressurize the rail, remove and replace the fuel metering unit on the high-pressure pump.

  4. Inspect/Replace the Pressure Relief Valve (PRV)

    If the rail pressure exceeded the maximum peak, the mechanical pressure relief valve on the fuel rail may have been compromised. If the PRV is leaking by or fails to hold pressure after the metering unit is addressed, replace the PRV.

  5. Clear Codes

    Use the E.A.S.Y. diagnostic tool (or equivalent CNH scanner) to clear the EDC fault codes and road/load test the machine to ensure rail pressure remains within specified limits.

Parts you might need

(10)
  • Fuel Metering Unit (Quantity Control Valve / MPROP)

    0928400481
  • Fuel Metering Unit (Quantity Control Valve / MPROP)

    0440030001
  • Fuel Metering Unit (Quantity Control Valve / MPROP)

    1462C00998
  • Fuel Rail Pressure Relief Valve (PLV)

    837079623
  • Fuel Rail Pressure Relief Valve (PLV)

    1110010022
  • Fuel Rail Pressure Relief Valve (PLV)

    1110010028
  • Primary and secondary fuel filters/water separators

Get help to fix this fault by requesting a quote

Browse other New Holland codes