New Holland 3929 – EDC (Electronic Diesel Control): Fuel pressure control Pressure Relief valve: maximum rail pressure in limp home mode with PRV and empty fuel tank
Issue description
The common rail fuel system experienced a dangerous over-pressure condition, which forced the mechanical Pressure Relief Valve (PRV) on the fuel rail to pop open. To protect the engine from catastrophic damage, the system automatically defaults to a 'limp home' (derated power) mode. This condition was detected alongside an empty (or starved) fuel tank scenario.
Applies to these machines
9 machines- T4 series (T4.65
- T4.75
- T4.105)
- T5 series
- T6000 series
- T7 series
- T9 series
- SWB PUMA models
- B90B-B115B backhoe loaders
Check the cause
Verify the fuel tank is not empty. Clean the tank if necessary, paying close attention to the bottom and sidewalls for debris that could cause a restriction.
Perform an air ingress test by installing a clear test line before the inlet of the high-pressure pump. Run the engine at low and high idle to observe for air bubbles (a steady stream indicates an air leak).
Test the low-pressure supply by placing a pressure gauge on the low-pressure side. Pressure between the filter and high-pressure pump should maintain a minimum of 5 bar (72 psi). A drop below 0.276 bar (4.0 psi) indicates a severe restriction.
Inspect the fuel pre-filter, main fuel filter(s), and all Voss O-ring fittings for leaks, blockages, or improper connections.
Repair steps
Depressurize the System
Turn off the machine and allow the engine to sit so the high-pressure fuel rail can depressurize. Warning: Common rail systems operate at extreme pressures (up to 25,000 PSI) which can cause severe injury.
Clean the Area
Thoroughly clean the fuel rail and the area around the PRV. Extreme cleanliness is required, as microscopic contamination can destroy common rail components.
Remove the PRV
Disconnect the fuel return line from the Pressure Relief Valve on the fuel rail, then unthread the faulty PRV from the rail.
Install the New Valve
Thread the new PRV into the fuel rail and torque it to the exact OEM specification found in your specific engine's service manual.
Reassemble and Prime
Reconnect the fuel return line. Replace the fuel filters and prime the fuel system with fresh, filtered fuel to purge any air.
Clear Codes
Connect a diagnostic tool (such as the CNH E.A.S.Y. system) to the EDC, clear fault code 3929, and test run the machine to ensure rail pressure stabilizes and the code does not return.
Parts you might need
(3)Fuel Rail Pressure Relief Valve (PRV)
837079623- Fuel Rail Pressure Relief Valve (PRV)5801474163
- Fuel Rail Pressure Relief Valve (PRV)5801483106
Get help to fix this fault by requesting a quote