3937

New Holland 3937 – Engine Control Unit (ECU): Air Temp in AFS: Signal range high on the duty cycle signal

Issue description

This code indicates that the duty cycle signal coming from the Air Temperature sensor—which is integrated into the AFS (Air Flow Sensor / Mass Air Flow sensor)—is exceeding the maximum expected range. Technically, this usually points to an open circuit, a short to power in the sensor's signal wire, or an internal failure of the sensor itself.

Applies to these machines

  • T6 Series
  • T7 Series
  • Boomer compact tractors
  • Boomer 45
  • CR Series
  • CR9065

Check the cause

  1. Visually inspect the AFS (Mass Air Flow) sensor on the engine's air intake piping. Check the wiring harness and connector for physical damage, melted wires, corrosion, or pushed-back pins.

  2. Using a multimeter, verify that the sensor is receiving the correct 5V reference voltage and has a solid ground connection to the ECU.

  3. Test the duty cycle signal wire between the AFS sensor connector and the Engine ECU harness for continuity. Check for a short to voltage, which would cause the 'signal range high' condition.

  4. Connect the New Holland E.A.S.Y. diagnostic tool and monitor the live data for the AFS Air Temperature duty cycle. If the value is pegged high and drops when the sensor is unplugged, the sensor is likely internally shorted. If it remains high when unplugged, there is a short to power in the wiring harness.

Repair steps

  1. Disconnect battery

    Turn off the machine's ignition and disconnect the negative battery cable to prevent electrical spikes.

  2. Locate AFS sensor

    Locate the AFS (Mass Air Flow) sensor on the air intake tube between the air filter housing and the turbocharger/intake manifold.

  3. Disconnect electrical harness

    Depress the locking tab and disconnect the electrical harness connector from the sensor.

  4. Remove mounting fasteners

    Remove the mounting fasteners (usually two Torx or hex bolts) securing the sensor to the intake housing.

  5. Remove old sensor

    Carefully pull the old sensor straight out of the intake tube.

  6. Lubricate O-ring

    Lubricate the O-ring on the new AFS sensor lightly with clean engine oil to prevent tearing.

  7. Insert new sensor

    Insert the new sensor into the intake housing, ensuring it is seated flush so unmetered air cannot leak past the seal.

  8. Reinstall fasteners

    Reinstall and tighten the mounting fasteners.

  9. Reconnect electrical harness

    Reconnect the electrical harness connector until it clicks securely into place.

  10. Clear fault code and test

    Reconnect the battery, turn the key to the ON position, and use your diagnostic tool to clear fault code 3937. Start the engine and verify the code does not return.

Parts you might need

(4)

Get help to fix this fault by requesting a quote

Browse other New Holland codes