3987

New Holland 3987 – ECU: Fuel Solenoid Position Sensor Low Voltage Red

Issue description

The Engine Control Unit (ECU) has detected that the voltage signal from the fuel solenoid's position sensor is below the expected range. This sensor reports the precise position of the fuel solenoid or fuel rack to the ECU, which is essential for controlling fuel delivery to the engine. A low voltage reading suggests a short to ground, a wiring issue, or a failure within the sensor itself. This is a critical 'Red' level fault that can lead to severe engine performance problems or a complete failure to start.

Applies to these machines

  • L218
  • L220
  • C227
  • L213
  • L216
  • 200 Series

Check the cause

  1. Visually inspect the wiring harness leading to the fuel injection pump and the fuel shut-off solenoid for chafing, corrosion on connectors, or pinched wires

  2. Listen for an audible 'click' from the fuel shut-off solenoid when the ignition key is turned to the 'ON' position (without starting the engine). The absence of a click indicates a lack of power to the solenoid or a failed solenoid

  3. Using a multimeter, check for proper voltage at the solenoid's electrical connector when the key is on to confirm the low voltage condition

  4. Test the resistance of the solenoid coil and compare it to manufacturer specifications (an infinite reading indicates an open circuit, while a near-zero reading suggests a short circuit)

  5. Check for continuity on the signal wire between the sensor and the ECU to rule out a break in the wire

Repair steps

  1. Ensure safety and locate component

    Park the machine on a level surface, engage the parking brake, turn the engine off, and disconnect the battery. Locate the fuel solenoid and its integrated position sensor on the fuel injection pump.

  2. Address wiring issues

    If diagnostic checks reveal any issues with the wiring or connectors, repair or replace the damaged sections. Ensure all connections are clean and secure.

  3. Replace the fuel shut-off solenoid

    If the wiring is intact and the solenoid/sensor is determined to be faulty, replace the entire fuel shut-off solenoid assembly (the sensor is integrated and not sold separately). Unplug the electrical connector, carefully unscrew and remove the old solenoid (expect minor fuel spillage), install the new solenoid ensuring it is threaded correctly and tightened to specification, and reconnect the wiring.

  4. Final system check

    Reconnect the battery, turn the ignition on, and listen for the 'click' of the new solenoid engaging. Clear the fault code using a diagnostic tool and start the engine to verify that the repair has resolved the issue.

Parts you might need

(7)
  • Primary OEM part for ISM engine parts. Compatible with a wide range of New Holland equipment.

  • Fuel Shut-Off Solenoid

    SBA185206083

    Alternative/superseded part number. Compatible with models including the L220.

  • Alternative/superseded part number. Compatible with models including the L220.

  • Throttle/Fuel Shutoff Solenoid

    185206510

    Compatible with models like the L213 and L216.

  • Fuel Injection Pump Assembly

    2856537

    For T4050F Tractor. Verify fitment.

  • Sensor5803368079

    For T4050F Tractor (replaces 2856350). Described in diagrams as water temp sensor, verify correct application for rack position.

  • Sensor87612475

    Generic sensor listed for L220 Skid Steer. Verify correct application.

Get help to fix this fault by requesting a quote

Browse other New Holland codes