4005

New Holland 4005 – ARU: Signal of Aux-stick (AUX2) Out of Range Low

Issue description

The Armrest Control Module (ARU) has detected that the voltage signal from the second auxiliary joystick (Aux-stick 2) is below the expected operational range. This indicates a potential issue with the signal integrity, which is typically caused by a failing internal potentiometer within the joystick, damaged wiring between the joystick and the control module, or a fault within the control module itself.

Applies to these machines

  • T5.110
  • T5.120
  • T5.130
  • T5.140
  • T6.140
  • T6.145
  • T6.150
  • T6.155
  • T7.175
  • T7.210
  • T7.220
  • T7.235
  • T7.250
  • T7.260
  • T7.270
  • T8.360
  • TM120
  • TM130
  • TM140
  • MXM Series

Check the cause

  1. Check for other active faults. Multiple 'out of range' or 'voltage low' codes could indicate a systemic issue, such as a problem with the 5-volt reference supply from the controller.

  2. Visually inspect the wiring harness and connectors between the armrest and the auxiliary joystick. Look for chafing, pinching, corrosion, and ensure all pins are properly seated at the joystick base and chassis harness connection.

  3. Disconnect the tractor's battery and gain access to the joystick's internal components by removing the armrest covers to test the AUX2 potentiometer.

  4. Measure the total resistance between the two outer terminals of the potentiometer to ensure it matches the rated value (e.g., 5kΩ or 10kΩ).

  5. Measure resistance between the center terminal (wiper) and an outer terminal while slowly moving the joystick through its full range of motion. The reading should change smoothly; erratic behavior, drop-offs to zero, or infinite readings indicate a faulty potentiometer.

Repair steps

  1. Replace faulty component

    If the potentiometer is identified as faulty and is available as a separate part, desolder it from the joystick's circuit board and install a new one (requires soldering skills). Alternatively, for a more straightforward repair, replace the entire auxiliary joystick assembly by unplugging the old joystick and installing the new one.

  2. Access calibration menu

    After replacing the component, access the tractor's onboard diagnostic service menu (often the 'H' menu) and navigate to the auxiliary controller or armrest calibration section (e.g., 'AUX LEVER').

  3. Calibrate AUX2 joystick

    Select the AUX2 remote to be calibrated. Follow the on-screen prompts to move the joystick to its full extent in all directions, then return it to the neutral position.

  4. Save and cycle power

    Save the new calibration values and exit the service menu. Turn the ignition off and back on to permanently store the calibration values.

Parts you might need

(8)
  • Auxiliary Joystick Assembly (Remanufactured)

    90493664R

    Fits various T5, T6, and T7 models. Verify correct part number for specific tractor model and serial number.

  • Confirm specific application to the AUX2 joystick with a dealer parts catalog.

  • Potentiometer

    86729675

    Confirm specific application to the AUX2 joystick with a dealer parts catalog.

  • Mid-mount hydraulic joystick

    47796164

    fits New Holland SideWinder tractors

  • Armrest Assembly with Joystick and Aux Control

    51575646
  • New Holland Armrest Joystick Controls

    47585526

Get help to fix this fault by requesting a quote

Browse other New Holland codes