4010

New Holland 4010 – MCC1: Display to MCC1 Communication Interruption

Issue description

The system has detected a loss of communication on the Controller Area Network (CAN bus) between the Universal Display and the MCC1 controller. This interruption prevents the exchange of information between these electronic control units, which may affect the operator's ability to monitor or control certain machine functions through the display.

Applies to these machines

  • CR920
  • CR940
  • CR960
  • CR970
  • TN-A Series
  • TD Series
  • TD5000 Series

Check the cause

  1. Inspect the wiring harness and connectors between the Universal Display and the MCC1 controller for chafed wires, broken wires, loose or corroded pins, and moisture intrusion

  2. Verify both the Universal Display and the MCC1 controller are receiving correct voltage and have a solid ground connection (check for related power fault codes like 8000 and 8001)

  3. With machine power off, measure CAN bus resistance between CAN High and CAN Low (should be approximately 60 Ohms; 120 Ohms indicates a missing terminating resistor, near 0 Ohms indicates a short)

  4. With machine power on, measure CAN bus voltage (CAN High should be 2.5-3.5V, CAN Low should be 1.5-2.5V). When the bus is idle, both should be at approximately 2.5V. Abnormal readings can indicate shorts to power or ground.

Repair steps

  1. Address Other Fault Codes

    Check for and address any other active fault codes, especially those related to power supply (e.g., 8000, 8001) or other controllers on the network.

  2. Perform Diagnostic Checks

    Follow the diagnostic checks outlined in the section above to isolate the root cause of the communication failure.

  3. Isolate the Fault

    If the wiring and network integrity appear to be good, the issue may lie with one of the modules. Try disconnecting other controllers from the CAN bus one at a time to see if communication is restored. This may require a breakout harness and specialized knowledge.

  4. Check for Software Updates

    Ensure the software for the display and controllers is up to date, as communication issues can sometimes be resolved with a software update. This may require a dealer's assistance with the New Holland Electronic Service Tool (EST).

  5. Component Replacement

    If a component (the Universal Display, the MCC1 controller, or a section of the wiring harness) is identified as faulty, it will need to be replaced.

Parts you might need

(6)
  • Fits a wide range of New Holland equipment including combines, forage harvesters, and tractors

  • Remanufactured AFS Display Monitor

    295133A3

    Fits some New Holland Combines (CR920, CR940, CR960, CR970)

  • 10.4-inch color touchscreen display

  • Compatible with TN-A, TD, and TD5000 series tractors

  • Generic CAN bus wiring harness

  • MCC1 Controller

    Specific OEM part numbers not found; contact dealer with model/serial number

Get help to fix this fault by requesting a quote

Browse other New Holland codes