4015

New Holland 4015 – ARU: Signal from Remote Flow Potentiometer 4 (AUX 4) Out of Range

Issue description

The Arm Rest Module (ARU) has detected that the electrical signal from the Remote Flow potentiometer for the AUX 4 circuit is outside of its expected voltage range. This indicates a potential open circuit, short circuit, or internal failure of the potentiometer component, which disrupts the control of the number 4 auxiliary remote valve.

Applies to these machines

  • T6010
  • T6020
  • T6030
  • T6040
  • T6050
  • T6060
  • T6070
  • T7030
  • T7040
  • T7050
  • T7060
  • TM115
  • TM120
  • TM125
  • TM130
  • TM135
  • TM140
  • TM150
  • TM155
  • TM165
  • TM175
  • TM190
  • T4020
  • T4030
  • T4040
  • T4050

Check the cause

  1. Review the system for any other active fault codes, particularly those related to the Arm Rest Module (ARU) or CAN bus communication, which could indicate a broader electrical issue

  2. Visually inspect the wiring harness and connector for the AUX 4 potentiometer for chafing, corrosion, broken wires, or bent pins

  3. Test the potentiometer with a multimeter to ensure fixed total resistance across outer terminals and smooth resistance changes between the center signal wire and outer terminals while moving the control lever

  4. Back-probe the connector with the key on to verify the correct reference voltage (typically 5V or 8V) and a good ground connection

Repair steps

  1. Recalibrate remote valves

    Ensure hydraulic oil is at normal operating temperature. Enter the diagnostic/calibration 'H' menu, select Remote 4 calibration, and follow on-screen prompts to move the lever to full extend and retract positions. Turn key off to store values.

  2. Replace potentiometer

    If calibration fails or the fault immediately returns, access the armrest control panel, disconnect the electrical connector, remove the knob, and unscrew the retaining nut to remove the faulty potentiometer. Install the new component, reassemble the armrest, and perform the remote valve recalibration procedure again.

Parts you might need

(5)
  • Compatible with many TM, T6000, and T7000 series tractors. Verify correct part number for your specific model and serial number with a dealer.

  • Common individual potentiometer replacement for various CNH armrests

  • Electronic Armrest & EDC Control Module

    87399131

    Fits New Holland T7000 series. Alt: 87631906

  • Electronic Armrest & EDC Control Module

    87631906

    Alternative to 87399131

  • Fits TJ series

Get help to fix this fault by requesting a quote

Browse other New Holland codes