4103

New Holland 4103 – UCM / IC / DCU / EDC: Rear Remote Valve 1 Safe Mode

Issue description

The electronic control module has placed the number 1 rear remote hydraulic valve into a 'safe mode' to prevent potential damage to the hydraulic system or implement. This protective measure disables or limits the valve's functionality and is triggered by an abnormal condition, which could be an electrical fault, mechanical binding, or an internal valve failure.

Applies to these machines

  • T7.200
  • T7.220
  • T7.260
  • T7.315
  • T8 Series
  • T9.390
  • T9.450
  • T9.505
  • T9.560
  • T9.615
  • T9.670

Check the cause

  1. Check for other active fault codes related to the rear remote valve (codes 4100-4113) such as 4104/4105 (under/over-voltage), 4106/4107 (spool movement too low/high), 4109 (manually operated), or 4110/4111 (faulty driver or potentiometer)

  2. Restart the tractor to see if the fault is intermittent and clears upon reboot

  3. Inspect the wiring harness and connectors leading to the No. 1 remote valve for damage, corrosion, or loose connections

  4. Verify that all fuses related to the hydraulic and electronic control systems are intact

  5. Check the hydraulic fluid level, ensure it is the correct specified type (e.g., Ambra Multi G 134), and check for contamination

  6. Observe overall hydraulic performance; sluggishness across all functions may indicate a sticking hydraulic compensator valve on the main pump

  7. Attempt to recalibrate the remote valves through the tractor's diagnostic menu, as a lost calibration can trigger this fault

Repair steps

  1. Address specific fault codes

    If any specific fault codes (4100-4113) are present alongside 4103, diagnose and resolve them first as they point to the exact root cause.

  2. Perform electrical repair

    If an electrical issue is suspected (e.g., codes 4104, 4105), use a multimeter to check for correct voltage and continuity at the valve's electrical connector. Repair any damaged wiring or faulty connections.

  3. Inspect and repair mechanical binding

    If a spool movement issue is indicated (e.g., codes 4106, 4107), inspect the valve for obstructions or mechanical binding. Check and replace internal O-rings if they have failed and are reducing hydraulic flow.

  4. Calibrate remote valves

    Perform the remote valve calibration procedure through the tractor's diagnostic menu or instrument cluster display to allow the controller to learn the valve's operational range. This is required after any repairs or if calibration loss is suspected.

  5. Replace faulty components

    If diagnostic checks or an unsuccessful calibration point to an internal failure (e.g., code 4111 indicating a faulty driver or potentiometer), replace the entire remote valve section or the affected control lever potentiometer in the armrest.

Parts you might need

(4)
  • Fits some New Holland T6000 series and Case IH Maxxum models

  • Fits a wide range of Ford/New Holland tractors

  • Rear Remote Hydraulic Valve Kit

    MT20116103

    Dealer-installed accessory kit

  • Single Spool Rear Remote Valve Kit

    718334006

    Single spool rear remote valve kit

Get help to fix this fault by requesting a quote

Browse other New Holland codes