4123

New Holland 4123 – EHR: Remote Valve 2 Manual Operation Detected

Issue description

The electronic control system has detected that the No. 2 rear electro-hydraulic remote (EHR) valve is operating in manual mode. This unexpected status is reported by the valve's electronic controller during normal automatic operation. It can be triggered by a stuck spool, an internal valve issue, or a failure in the electronic control components that forces the valve into a failsafe manual mode.

Applies to these machines

  • T8 Series
  • TM120
  • TM130
  • TM140
  • TM155
  • TM175
  • TM190

Check the cause

  1. Visually inspect the No. 2 remote valve, lever, and linkages for physical damage, binding, or obstructions that could prevent the spool from moving freely

  2. Check hydraulic fluid level and condition (milky fluid indicates water contamination, which can cause valve failures)

  3. Attempt to operate the valve using its manual override and cab controls, noting any unusual hissing or whining noises indicating pressure imbalances

  4. Observe hydraulic performance for slow or jerky implement movements or an inability to lift heavy loads

  5. Inspect the valve stack for hydraulic fluid leaks indicating failed O-rings or seals

  6. Use an Electronic Service Tool to view live data, run diagnostic tests, or perform calibration routines

Repair steps

  1. Prepare tractor safely

    Park on a level surface, turn off the engine, engage the parking brake, and relieve residual hydraulic pressure by moving the remote levers back and forth.

  2. Clean valve area

    Thoroughly clean the area around the remote valve stack to prevent dirt and debris from entering the hydraulic system.

  3. Remove valve section

    Disconnect the hydraulic lines and unbolt the No. 2 valve section from the stack. Be prepared for residual fluid spills.

  4. Disassemble valve

    Carefully disassemble the valve section, paying close attention to the order and orientation of the main spool, shuttle valves, springs, and shims.

  5. Replace seals and O-rings

    Inspect and replace all O-rings and seals within the valve body. Pay special attention to those on the primary and secondary shuttle valves, as their failure dramatically reduces hydraulic flow.

  6. Clean and inspect components

    Clean all metal components with a suitable solvent. Inspect for wear, scoring, or damage, and replace any parts that show significant wear.

  7. Reassemble valve

    Reassemble the valve using the new seals and O-rings. Use hydraulic assembly lube on the seals to prevent damage during installation.

  8. Reinstall and test

    Reinstall the valve section, torque all bolts to manufacturer specifications, top off the hydraulic fluid, and test operation. Perform a calibration routine if necessary.

Parts you might need

(6)
  • Remote Valve Seal Kit/Repair Kit

    87694923

    Example part number for T5050. Verify exact fitment via parts catalog.

  • O-Rings14457281

    Example part number for T5050. High-temperature type recommended.

  • Valve Spool

    87306635

    Example part number for T5050.

  • Hydraulic Valve Assembly

    84161439

    Example part number for Workmaster 55.

  • Example part number for TM120/TM150.

  • Remanufactured Hydraulic Valve

    87526168R

    Example part number for TM150. Cost-effective alternative to a new assembly.

Get help to fix this fault by requesting a quote

Browse other New Holland codes