New Holland 4138 – EHR: Rear Remote 3 Driver Faulty
Issue description
The fault code indicates a malfunction in the electrical circuit responsible for operating the third electro-hydraulic remote (EHR) valve. The 'driver' is an electronic component, typically a transistor within the control module, that switches power to the solenoid on the hydraulic valve. The control module has detected an issue with this driver circuit, such as an open circuit, a short circuit, or an inability to provide the correct voltage to the solenoid.
Applies to these machines
22 machines- T4 Series
- T6 Series
- T6010
- T6020
- T6030
- T6040
- T6050
- T6060
- T6070
- T6080
- T7 Series
- T7.170
- T7.185
- T7.200
- T7.210
- T7.220
- T7.235
- T7.250
- T7.260
- T7.270
- T8 Series
- T9 Series
Check the cause
Check hydraulic fluid level and ensure it is at normal operating temperature, as low or cold fluid can cause erratic behavior.
Check for related active fault codes (e.g., 4139, 4140, or 4141) which can provide additional clues.
Visually inspect the wiring harness and connectors leading to the number 3 rear remote valve for chafing, corrosion, or loose connections.
Swap the electrical connector from the number 3 remote valve solenoid with an adjacent, functioning remote (e.g., number 4) to see if the fault follows the wiring/module or stays with the solenoid.
Using a multimeter, check for continuity in the wiring between the control module and the number 3 remote valve solenoid.
Measure the resistance of the solenoid coil. A typical resistance for an EDC valve solenoid is between 6 and 8 ohms. Infinite resistance (open circuit) or very low resistance (short circuit) indicates a faulty solenoid.
Repair steps
Repair wiring and connectors
If damage was found during visual inspection or continuity testing, repair or replace the affected sections of the wiring harness or connectors. Ensure all connections are clean and secure.
Replace the solenoid
If the solenoid on the number 3 remote valve failed the resistance test or the swap test, remove it from the valve body, install a new one, and reconnect the electrical connector.
Repair or replace the control module
If diagnostics point to a faulty driver within the control module (wiring and solenoid are good), the module will need to be repaired by a specialized electronics service or replaced with a new/remanufactured unit.
Calibrate the EHR system
After replacing a valve or control module, perform a calibration of the EHR system through the tractor's diagnostic menu to ensure the control module correctly recognizes the new component's operating parameters.
Parts you might need
(6)EHR Control Module
86029094General part number for an EHR control module; verify fitment for the specific tractor model
Electronic Armrest Lift/EHR Control
87648539For some T6000 series models
Fits various T6 and T7 series tractors
- Remanufactured EH Lever Control47372893R
Remanufactured 8-Volt EH Lever Control
- Remote Valve Wiring Harness87351208
T8 series reference
- Remote Valve Wiring Harness87748970
T8 series reference
Get help to fix this fault by requesting a quote