4154

New Holland 4154 – ARU: Remote No.4 Unable To Reach Neutral

Issue description

The electronic control system has detected that the spool for the number 4 electro-hydraulic remote (EHR) valve is not in its neutral position when commanded. This condition prevents the proper operation of the hydraulic circuit associated with that remote, potentially causing implements to drift or not function correctly. The system logs this fault after being unable to verify that the valve spool has centered.

Applies to these machines

  • T7
  • T8
  • T9

Check the cause

  1. Verify the control lever or paddle for remote #4 on the armrest is physically in the neutral position and not stuck. Faulty potentiometers within these levers are a common issue and can fail to signal the neutral position correctly.

  2. Check for related active fault codes, such as 4153 (Remote no. 4 potentiometer defective) or 4155 (Remote no. 4 spool not in neutral at key on), which can help pinpoint the root cause.

  3. Inspect the wiring harness and connectors between the armrest controller and the #4 remote valve assembly for signs of corrosion, damage, or loose connections.

  4. Test solenoid operation by listening for a 'click' when the remote is activated. Check for correct voltage at the solenoid and test the coil's resistance (infinite resistance indicates an open circuit; near-zero indicates a short circuit).

  5. Inspect for hydraulic fluid contamination or mechanical blockages that could cause the valve spools to stick. In some cases, sluggish hydraulic performance can be traced to a sticking compensator valve on the main hydraulic pump.

Repair steps

  1. Prepare machine for calibration

    Park the tractor on a level surface, engage the parking brake, and ensure the wheels are securely blocked. Disconnect any implements from the remote valves.

  2. Enter diagnostic mode

    With the engine running at a low idle (or as specified by the manual), navigate to the diagnostic or 'H' menu on the tractor's instrument cluster display.

  3. Select EHR calibration

    Navigate to the EHR (Electronic Hydraulic Remote) calibration menu (often denoted as H1 or similar). The display should indicate it is ready for calibration by showing 'CAL'.

  4. Initiate calibration for Valve #4

    Select remote valve #4 using the appropriate controls. This may involve pressing a button on the armrest multiple times or using the display menus.

  5. Follow on-screen prompts

    Move the control lever for remote #4 to its full extent in each direction (e.g., extend, retract, float). Hold the lever in each position until the system acknowledges it with a beep or a change on the display.

  6. Save and verify

    Once the sequence is complete, turn the key to the 'OFF' position to save the settings. Restart the tractor and test the operation of remote #4 to verify the fault code is no longer active.

  7. Replace faulty hardware

    If the valve fails to calibrate or the fault code returns immediately, replace the remote valve's control lever (potentiometer) in the armrest or the electronic/solenoid portion of the valve assembly.

Parts you might need

(4)
  • 4th Electronic Remote Valve Kit

    710393651

    Verify fitment with dealer using machine serial number

  • 4 Section Remote Hydraulic Valve Assembly L/HPL

    86024150

    Verify fitment with dealer using machine serial number

  • CNH original part

  • Remote Control Lever

    Potentiometer assembly in the armrest. Highly specific to armrest version; order via dealer using serial number.

Get help to fix this fault by requesting a quote

Browse other New Holland codes