New Holland 4156 – ARU: EHR Valve 5 No Signal
Issue description
The system is reporting that no signal is being received for remote valve 5 in the primary hydraulic power system. This indicates a failure in the communication or control process for this specific component, likely due to a CAN bus communication error or a wiring problem. The control module is unable to detect the presence of or receive a response from the valve.
Applies to these machines
5 machines- T5
- T6
- T7
- T8
- T9
Check the cause
Check battery voltage (must be at least 12.6V) and ensure all battery and chassis ground connections are clean and tight to rule out voltage-induced ghost faults
Check all relevant fuses and relays related to the hydraulic and electronic control systems
Visually inspect the wiring harness and connectors leading to the number 5 remote valve (typically at the rear of the tractor) for damage, corrosion, or loose connections
Repair steps
Verify fault codes
Use the New Holland Electronic Service Tool (EST) to confirm fault code 4156 is active and to check for any other related codes.
Check for Manual Override
Ensure the manual override lever on the remote valve has not been activated, as it can disable electronic control.
Inspect and clean connectors
Disconnect the wiring connectors for remote valve number 5. Inspect for pin damage or corrosion, clean as necessary, and securely reconnect the main connectors to the valve stack and the controller.
Swap components for diagnosis
Swap the electrical components (solenoid or valve slice) of valve 5 with a known working valve (e.g., valve 4). If the fault moves to the new position, replace the faulty valve component. If the fault remains on valve 5, the issue is in the wiring harness or the control module.
Calibrate the valve
If components were replaced or system memory was lost, perform a valve calibration using the tractor's built-in display or the EST to clear communication errors.
Parts you might need
(6)Representative OEM part number for similar component; verify fitment by serial number
Control Valve
84266155Generic control valve part number; verify fitment by serial number
O-ring
51622930Recommended to replace when replacing a valve section to prevent leaks
- O-ring14457281
Recommended to replace when replacing a valve section to prevent leaks
Valve Solenoid
Actuates the valve spool
Wiring Harness/Pigtail
Required if the existing wiring is damaged
Get help to fix this fault by requesting a quote