4172

New Holland 4172 – EHR: Rear EHR Control No.1 Short Circuit

Issue description

The EHR control module (DU Module) has detected a short circuit in the electrical circuit for the No. 1 rear Electronic Hydraulic Remote (EHR) valve. This indicates an unintended path of low resistance to ground or between wires, causing excessive current flow. This electrical issue will likely disable the function of the corresponding rear remote valve.

Applies to these machines

  • T4
  • T5
  • T6
  • T7
  • T8
  • T6000 Series
  • T6000 Delta
  • T6000 Plus
  • TM Series
  • TN-DA Series

Check the cause

  1. Visually inspect the wiring harness leading to the No. 1 rear EHR valve for chafed or melted insulation, pinched wires, corrosion in the connectors, or rubbing against the tractor frame or other components.

  2. Disconnect the electrical connector at the No. 1 EHR valve and inspect the terminals for corrosion, moisture, or damage. Ensure the terminals are clean and making a secure connection.

  3. Use the tractor's 'H' menu diagnostics (if equipped) to view stored fault codes and perform voltmeter diagnostics to check circuit integrity.

  4. With the key off and valve disconnected, use a multimeter to check resistance to ground (a very low reading indicates a short to ground).

  5. With the key off and valve disconnected, use a multimeter to check resistance between wires in the harness connector (a low reading indicates a short between wires).

Repair steps

  1. Isolate the fault

    Disconnect the wiring harness from the No. 1 rear EHR valve solenoid.

  2. Clear fault codes

    Clear the fault code 4172 from the control module.

  3. Check for code return

    Turn the key on and attempt to operate the remote. If the fault code does not return, the short circuit is likely within the EHR valve solenoid itself. If the fault code returns immediately with the valve disconnected, the short is in the wiring harness between the control module and the valve.

  4. Repair wiring harness

    If the fault is isolated to the wiring harness, carefully trace the wires from the EHR valve connector back to the control module. Repair or replace any damaged sections of the wiring, ensuring all repairs are sealed against moisture and vibration.

  5. Replace EHR valve or solenoid

    If the fault was isolated to the valve itself (code did not return when disconnected), replace the solenoid or the entire valve assembly.

  6. Calibrate the new valve

    After replacing an EHR valve or control module, perform a calibration procedure through the tractor's diagnostic 'H' menu to teach the control module the operational range of the new valve. Failure to calibrate may result in a 'Not Calibrated' fault code (e.g., 4170).

Parts you might need

(8)
  • Rear Remote Hydraulic Valve #1 Position Complete

    719936046

    Example OEM part number; verify fitment by serial number

  • Remote Control Valve w/ Mega Flow

    86026993

    Verify fitment by serial number

  • Rear Remote Hydraulic Valve Kit

    MT20116103

    Verify fitment by serial number

  • Remote Valve Kit

    731200551

    Verify fitment by serial number

  • Alternative/Superseded: 82024122. Fitment: T7000 Series, TM175, TM190

  • Electronic Armrest Lift & EHR Control Assembly

    87648539

    Fitment: T6000 Series (T6030, T6050, T6070, T6080)

  • EHR Control Valve Wire Harness

    84158327

Get help to fix this fault by requesting a quote

Browse other New Holland codes