4179

New Holland 4179 – TCU: EHR Control No.3 Short Circuit

Issue description

The electronic control system has detected a short circuit in the electrical circuit for the number 3 Electronic Hydraulic Remote (EHR) valve. This indicates an electrical issue where the control signal wire is likely shorted to a power source or ground, which prevents the proper operation of the associated hydraulic system and implement control.

Applies to these machines

  • T6 Series
  • T7 Series
  • T7.170
  • T7.220
  • T6000 Series
  • Delta
  • Plus
  • Elite
  • T6030
  • T6050
  • T6070
  • T7000 Series
  • TS-A Series

Check the cause

  1. Visually inspect the wiring harness leading from the cab controls to the #3 rear EHR valve for chafed, pinched, or melted insulation

  2. Inspect electrical connectors at the cab control switch/lever, intermediate connection points, and the EHR valve solenoid for moisture ingress and corrosion

  3. Perform component isolation by disconnecting components one by one to see if the fault code clears

  4. Check battery and system voltage to ensure it is fully charged (at least 12.6V) and that the charging system is functioning correctly, as low voltage can trigger erroneous codes

Repair steps

  1. Isolate the circuit

    Disconnect the electrical connector at the #3 EHR valve solenoid. Turn the ignition on and check if fault code 4179 remains active. If it disappears, the solenoid is likely faulty. If it remains, the short is in the harness or switch.

  2. Test the wiring harness

    With the valve solenoid disconnected, use a multimeter set to Ohms. Check for continuity between the EHR #3 signal wire and the tractor chassis (ground) to check for a short to ground. Then check continuity between the signal wire and the 12V power supply wire to check for a short to power.

  3. Inspect the control switch

    If the harness tests clear, access the control switch/lever in the cab. Disconnect its electrical connector, visually inspect for damage, and test for internal shorts according to OEM specifications.

  4. Repair or replace faulty components

    Repair damaged wiring harness sections, or replace the EHR valve solenoid or control switch depending on which component failed the isolation and continuity tests.

  5. Clear codes and calibrate

    Reconnect all components. Use the tractor's diagnostic menu or service tool to clear stored fault codes. Recalibrate the remote valve if required by the repair.

Parts you might need

(13)
  • Fits T6, T6000, T7, T7000, and TSA series tractors.

  • EHR Valve Solenoid

    87577678

    Example for T7000 series; verify exact part by tractor model and serial number. Solenoids may be color-coded.

  • Rear Remote Hydraulic Valve Kit / Assembly

    MT20116103

    Complete valve slice or assembly kit.

  • Rear Remote Hydraulic Valve Kit / Assembly (Mega Flow)

    86026993

    Complete valve slice or assembly kit for mega flow.

  • EHR Control Unit / Module

    82002539

    Repair services may be available.

  • Repair services may be available.

  • Repair services may be available.

  • Repair services may be available.

  • Electro-Hydraulic Remote Lever (Green)

    48002177

    Verify color and part number with dealer using tractor serial number

  • Verify color and part number with dealer using tractor serial number

  • Lever

    90434928

    Generic EHR lever

  • Remanufactured option

  • Electronic Armrest Lift/EHR Control

    87648539

    Entire armrest assembly for T6000 series

Get help to fix this fault by requesting a quote

Browse other New Holland codes