New Holland 4182 – EHR: Rear control unit EHR No. 4 - short circuit
Issue description
The electronic control system has detected a short circuit in the electrical circuit of the fourth Electronic Hydraulic Remote (EHR) valve. A short circuit indicates that electrical current is diverting from its intended path, which can cause the number 4 remote valve to become inoperative or behave erratically, affecting the proper operation of the associated implement or system connected to this unit.
Applies to these machines
6 machines- T4
- T6000
- T7
- T7000
- TM Series
- TM165
Check the cause
Visually inspect the wiring harness leading to the number 4 EHR valve solenoid for chafed or melted insulation, pinched wires, or corrosion, especially where it rubs against the frame.
Disconnect and inspect the electrical connector at the number 4 EHR valve solenoid for corrosion, moisture, or pushed-out pins.
Perform a solenoid resistance test: measure resistance across the two terminals of the disconnected solenoid (normal is 6-8 ohms; near zero indicates a short circuit within the coil, while an infinite reading indicates an open circuit/fault code 4181).
Test the wiring harness for a short to ground: measure resistance between each harness wire and a known good chassis ground (should be infinite/open circuit).
Test the wiring harness for a short to power: with the key 'on' and the remote not activated, check for battery voltage on the signal wire.
Repair steps
Isolate the fault
Based on the diagnostic checks, determine if the fault lies with the EHR solenoid, the wiring harness, or the control module.
Repair wiring harness
If a short circuit is found in the wiring harness, replace the damaged section of wire or repair the connector. Re-route the harness to prevent future damage and ensure all connections are properly sealed against moisture.
Replace EHR solenoid
If the solenoid coil is shorted (resistance near zero ohms), ensure the hydraulic system is not under pressure, unscrew the faulty solenoid (be prepared for a small amount of hydraulic fluid to leak out), install the new one to manufacturer specifications, and reconnect the electrical connector.
Replace EHR control unit
If both the wiring and the solenoid are in good condition, the fault may lie within the EHR control unit itself. Replace the control unit (this is the least common cause and may require programming by a certified New Holland technician).
Clear codes and calibrate
After repairs are complete, clear the fault codes using the tractor's diagnostic menu or an electronic service tool. Recalibrate the EHR valves as necessary.
Parts you might need
(8)- Rear Remote Valve Solenoid87638226
Replaces 5190767. Fits TM165, may not be universal.
- Rear Remote Valve Solenoid87635977
Replaces 5190768. Fits TM165, may not be universal.
Fits some T6000 series and Case IH Maxxum/Puma models.
EHR Control Unit (Armrest)
87648539Armrest control for T6000 series.
- EHR Control Unit82012644
Verify fitment by serial number.
- EHR Control Unit82024840
Verify fitment by serial number.
- EHR Control Unit87397177
Verify fitment by serial number.
EHR Valve Connector Kit
Source OEM parts from a New Holland dealer.
Get help to fix this fault by requesting a quote