4303

New Holland 4303 – EHR: Rear Remote No. 6 EEPROM Error

Issue description

The fault code indicates an EEPROM (Electrically Erasable Programmable Read-Only Memory) error or Checksum Verification Failure within the electronic control unit for the number 6 rear electro-hydraulic remote (EHR) valve. The data stored in the memory of the remote valve's controller is corrupt, unreadable, or has failed an integrity check, preventing the controller from verifying its settings and operating the valve correctly.

Applies to these machines

  • T7
  • T8
  • T9
  • Magnum 235
  • Magnum 340

Check the cause

  1. Attempt to clear the fault code using the tractor's diagnostic menu or Electronic Service Tool (EST), cycle the ignition key off and on, and check if the code reappears

  2. Check for other active fault codes related to the EHR system, armrest controller, or CAN bus communication, which could indicate a broader electrical issue

  3. Visually inspect the wiring harness and connectors leading to the number 6 rear remote valve for any signs of damage, corrosion, or loose connections that could cause intermittent data corruption

  4. Swap the electronic control portion (powerhead) between the faulty remote (#6) and a known working remote to see if the fault code follows the component, confirming a faulty module

Repair steps

  1. Attempt recalibration

    Perform a recalibration of the rear remote valves through the tractor's instrument cluster display or with the New Holland Electronic Service Tool (EST). A lost or corrupt calibration can sometimes trigger memory-related faults.

  2. Reprogram or re-flash the module

    If recalibration is unsuccessful, have a dealer technician use the EST to re-flash or update the software on the EHR controller to rewrite the internal programming and resolve the corruption.

  3. Replace the faulty component

    If reprogramming fails, the electronic control module on the number 6 remote valve is likely internally damaged and requires replacement. After replacing the valve section, configure and calibrate the new valve to the tractor using the EST.

Parts you might need

(6)
  • Listed for various New Holland and Case IH models. Verify fitment by serial number.

  • Remote valve47595558

    Compatible with New Holland T8 and T9 series tractors. Verify fitment by serial number.

  • Remote valve47434188

    Compatible with New Holland T8 and T9 series tractors. Verify fitment by serial number.

  • Remote valve

    87486189

    Compatible with New Holland T8 and T9 series tractors. Verify fitment by serial number.

  • Rear remote hydraulic valve kit

    MT20116103

    New Holland OEM kit. Verify fitment by serial number.

  • Two-spool remote valve kit

    719349006

    OEM kit. Verify fitment by serial number.

Get help to fix this fault by requesting a quote

Browse other New Holland codes