4510

New Holland 4510 – TMF / ARU / TCU: Primary Hydraulic Power System Electro-hydraulic Remote Valve Mid-mount Remote Control Valve, Front Remote No.1 - Driver Faulty

Issue description

This fault code indicates a problem with the electrical circuit that controls the electro-hydraulic remote (EHR) valve for the front remote number 1. The electronic driver within the control module, which sends electrical current to the hydraulic valve's solenoid, is malfunctioning. This is an electrical fault that could be caused by an open circuit, a short circuit, or an internal failure within the controller itself.

Applies to these machines

  • T7.170
  • T7.185
  • T7.200
  • T7.210
  • T8 Series
  • T9 Series
  • TG Series
  • TG245
  • TN75A
  • 4835

Check the cause

  1. Check fuses related to the hydraulic controller or armrest unit, and verify stable battery voltage and secure grounds.

  2. Inspect the wiring harness and connectors between the control module and the No. 1 front remote valve for chafing, breaks, or corrosion.

  3. Disconnect the valve solenoid and test its resistance using a multimeter to check for an open or short circuit.

  4. Ensure any manual overrides on the valve block are in their neutral or automatic position.

  5. Attempt to recalibrate the remote levers and valves through the tractor's display menu.

Repair steps

  1. Replace fuse

    If a blown fuse is found, replace it with one of the same rating and re-test. If it blows again, trace and repair the persistent short circuit.

  2. Repair wiring

    Repair any damaged wires in the harness, ensuring connections are secure and insulated. Replace any corroded connector pins.

  3. Replace solenoid coil

    If the solenoid tests faulty (open or shorted), ensure the tractor is off and hydraulic pressure is relieved, then unscrew the old coil from the valve body and install a new one.

  4. Replace control module

    If the solenoid and wiring are in good condition, the fault lies within the driver circuit inside the control module (ARU or TCU). Replace the module and have it programmed or calibrated by a qualified technician.

Parts you might need

(5)
  • Part numbers vary by tractor model; verify with dealer.

  • Mid-Mount Hyd Control Valve Kit

    719349006

    Part numbers vary by tractor model; verify with dealer.

  • Joystick/Control Lever

    87567643

    Example part number for armrest joystick control.

  • Replacement O-rings necessary if the valve block is disassembled or leaking.

  • Electro-Hydraulic Control Valve/Solenoid

    Specific to valve manufacturer (e.g., Bosch Rexroth) and tractor model.

Get help to fix this fault by requesting a quote

Browse other New Holland codes