5002

New Holland 5002 – Rear Power Take Off: PTO Switch Interlock Fault

Issue description

The control module has received illogical inputs from the PTO operating switches, indicating an issue with the PTO switch interlock. This is most commonly triggered by the simultaneous activation of the in-cab PTO switch and the rear fender-mounted PTO switch, which the system interprets as an invalid operational command. This interlock is a safety feature designed to ensure proper operation and prevent unexpected or unsafe PTO activation. A faulty switch can also cause this error, potentially preventing the tractor from starting if the system incorrectly believes the PTO is engaged.

Applies to these machines

  • T4
  • T5
  • T6
  • T7
  • TM115
  • TM125
  • TM135
  • TM150
  • TM165
  • TM175
  • TM190
  • TSA Series
  • T5030
  • T5040
  • T5050
  • T5060
  • T5070
  • T6000 Series
  • T7000 Series
  • Boomer 20
  • Boomer 24
  • Boomer 25
  • Boomer 30
  • Boomer 33
  • Boomer 35
  • Boomer 37
  • Boomer 40
  • Boomer 41
  • Boomer 47
  • Boomer 50
  • Boomer 55
  • Workmaster 25
  • Workmaster 33
  • Workmaster 35
  • Workmaster 37
  • Workmaster 40
  • Workmaster 45A
  • Workmaster 50A
  • Workmaster 55A
  • Workmaster 35C
  • Workmaster 40C
  • Workmaster 45C
  • Workmaster 50C
  • Workmaster 55C

Check the cause

  1. Verify that the in-cab PTO switch and the rear fender-mounted PTO switch are not being pressed or activated at the same time.

  2. Inspect both the cab and fender PTO switches to see if either is physically stuck in the 'on' position.

  3. Check for intermittent faults by wiggling the switches and their wiring harnesses to see if the fault can be replicated.

  4. Visually inspect the wiring harnesses leading to both the cab and fender PTO switches for any signs of damage, corrosion, or loose connections.

  5. Inspect the fuses related to the PTO circuit, as a blown fuse can sometimes cause erratic behavior in the system.

  6. Verify that other safety interlocks, such as the seat switch, are functioning correctly, as they are part of the overall PTO engagement logic.

Repair steps

  1. Disconnect the battery

    For safety, always disconnect the battery before beginning any electrical repairs.

  2. Access the faulty switch

    For the in-cab switch, remove the console panel to access the rear of the switch. For the fender-mounted switch, access it from the rear of the tractor.

  3. Document wiring

    Before disconnecting the old switch, take a clear photo of the wire connections to ensure the new switch is wired correctly.

  4. Remove the old switch

    Gently pry the plastic tabs holding the switch in place to release it from its mounting, then unplug the electrical connector.

  5. Install the new switch

    Apply a small amount of dielectric grease to the electrical connector pins to help prevent future corrosion. Connect the wiring harness to the new switch and push it into its mounting hole until it clicks into place.

  6. Reconnect battery and test

    Reconnect the battery and test the operation of the new switch. Ensure the PTO engages and disengages correctly, the fault code does not reappear, and the safety interlock prevents the tractor from starting with the PTO engaged.

Parts you might need

(11)

Get help to fix this fault by requesting a quote

Browse other New Holland codes