5015

New Holland 5015 – Rear PTO Controller: PTO Shaft Speed Not Detected

Issue description

The Rear PTO Controller has commanded the PTO engagement solenoid (initial fill valve) to activate, but the PTO speed sensor has not detected any rotation of the PTO shaft within a 3-second window. This indicates a failure in the system to confirm physical PTO rotation after being commanded, which can be caused by electrical faults in the sensor or solenoid circuits, blown fuses, or a mechanical failure in the PTO clutch or shaft.

Applies to these machines

  • T8.275
  • T8.300
  • T8.330
  • T8.360
  • T8.390
  • T8.420

Check the cause

  1. Visually inspect the wiring harness and connectors leading to the PTO speed sensor and engagement solenoid for damage, chafing, or corrosion, paying special attention to areas near the fenders or operator's seat

  2. Listen for an audible 'click' from the PTO solenoid when the engagement switch is activated (with engine running and safety interlocks met) to verify basic solenoid operation

  3. Inspect the PTO speed sensor for physical damage, corrosion at the terminals, or an excessive air gap between the sensor and the tone ring on the PTO shaft

  4. Check fuses and relays related to the PTO and transmission control systems (e.g., 12VH1 voltage supply) located in the engine compartment and under the operator's seat floor mat

Repair steps

  1. Repair wiring

    If any damaged wiring or connectors are found during the visual inspection, repair or replace them. Ensure all connections are clean and secure.

  2. Test PTO speed sensor

    Using a multimeter, check the PTO speed sensor for correct resistance and signal output according to the specifications in the official service manual. Replace the sensor if it is faulty.

  3. Test PTO solenoid

    If the solenoid does not 'click' when activated, test it for proper resistance and ensure it is receiving battery voltage when the PTO is commanded on. Replace the solenoid if it fails testing.

  4. Diagnose mechanical issues

    If the electrical components (sensor, solenoid, wiring) test correctly, inspect for mechanical faults such as a failed PTO clutch, a seized PTO shaft, or an issue within the hydraulic circuit that engages the clutch.

  5. Check controller and software

    If all physical and electrical components are functional, use the Electronic Service Tool (EST) to check for controller faults or required software updates.

Parts you might need

(9)
  • PTO Speed Sensor

    Generic part name. Verify part number with a dealer based on the tractor's serial number.

  • PTO Solenoid / Valve

    Generic part name. Verify part number with a dealer based on the tractor's serial number.

  • Mini type fuse

  • Mini type fuse

  • 20 Amp Fuse (Yellow)

    10401190

    Mini type fuse

  • 25 Amp Fuse (Clear)

    84127708

    Replaces 121415A1

  • 30 Amp Fuse (Green)

    10401290

    Replaces 121416A1

  • For T8 series tractors

  • Wiring Harnesses and Connectors

    Part numbers are specific to the harness section (e.g., Auxiliary Harness, Park Brake Switch Harness) and must be looked up in the parts catalog.

Get help to fix this fault by requesting a quote

Browse other New Holland codes