New Holland 5020 – New Holland Rear Power Take Off: PTO Configuration Mismatch

The PTO is configured as a single speed, but a shaft size frequency was detected when the PTO was switched on. This shaft size frequency input is only intended for a two speed PTO, indicating a configuration inconsistency.

1. 1

   PTO configuration settings

2. 2

   shaft size frequency input signal

3. 3

   PTO control unit settings

1. 1

   Verify

   The PTO configuration settings to ensure they match the actual PTO type installed.

2. 2

   Check

   The shaft size frequency input signal to confirm it is not being incorrectly detected or sourced.

3. 3

   Adjust

   The PTO control unit settings to align with the configured PTO type.