New Holland 5020 – Rear PTO: PTO Configured as Single Speed with Shaft Size Frequency Detected

The PTO is configured as a single speed, but the system detected a shaft size frequency when the PTO was switched on. This input is only intended for use with a two-speed PTO.

1. 1

   PTO configuration settings

2. 2

   shaft size frequency input signal

3. 3

   PTO control module

1. 1

   Verify PTO configuration

   Confirm that the PTO is correctly configured as a single speed according to the machine's specifications.

2. 2

   Check shaft size frequency input

   Inspect the shaft size frequency input to ensure it is not being incorrectly activated or misinterpreted by the system.

3. 3

   Review PTO control module

   Examine the PTO control module for any errors or misconfigurations that could be causing the frequency input to be detected.