New Holland 5025 – Rear PTO: Rear PTO Fault
Issue description
The system has detected a general or non-specific fault within the rear PTO system. Because the exact technical condition is not publicly defined in service manuals, this code often acts as a catch-all for rear PTO issues not covered by more specific codes, indicating a failure in the electrical, hydraulic, or mechanical engagement of the PTO.
Applies to these machines
5 machines- T8.xxx Series
- T4 Series
- T5 Series
- T6 Series
- T7 Series
Check the cause
Visually inspect the PTO shaft, wiring harnesses, and hydraulic lines for damage, leaks, or corrosion, especially near the rear of the tractor
Inspect all fuses and relays related to the PTO system for blown fuses or faulty relays
Verify safety interlocks: ensure the operator is seated, the seat switch is functioning, the transmission is in the correct gear/park, and the intentional PTO switch is activated if applicable
Check hydraulic/transmission fluid level, condition (look for water or debris), and inspect for clogged filters
Test cab-mounted and fender-mounted PTO switches for proper operation
Check for voltage at the PTO solenoid when the switch is engaged using a multimeter
Check for other, more specific fault codes (e.g., 5028, 5029 for speed sensors, or 5008, 5009 for solenoids) that can help pinpoint the issue
Repair steps
Address simple fixes
Replace any blown fuses or faulty relays identified during inspection. If hydraulic fluid is low or contaminated, correct the level and/or replace the fluid and filters.
Repair electrical faults
Replace faulty switches or repair damaged wiring harnesses. If the PTO solenoid receives power but does not actuate (click), replace the solenoid.
Address hydraulic issues
If hydraulic pressure is low despite correct fluid levels and clean filters, investigate the hydraulic pump or internal leaks within the PTO clutch piston seals. This may require specialized tools.
Repair mechanical failures
If electrical and hydraulic systems are functioning correctly, inspect and replace worn mechanical components such as the PTO clutch pack or broken PTO brake band. Note: This typically requires splitting the tractor or removing the lift cover.
Clear fault codes
After performing repairs, clear the fault codes from the controller's memory and operate the tractor to ensure the fault does not return.
Parts you might need
(8)- Rear PTO Solenoid Valve47658159
- Rear PTO Solenoid Valve87739558
- Rear PTO Solenoid Valve84273815
Fits many Farmall, Maxxum, and T-series models
- Rear PTO Solenoid Valve51433464
Fits TD5 and Farmall models
- Rear PTO Safety Switch (Normally Open)SBA385200731
Replaces SBA385200730
- PTO Control Lever5180817
Fits TN55, TN65
PTO Control Support
5177068Fits various TN series tractors
Rear PTO Assembly
9601631Fits 411 Mower-Conditioner
Get help to fix this fault by requesting a quote