6005

New Holland 6005 – TCM or TMF: Both Differential Lock Switch and Automatic Differential Lock Switch Activated

Issue description

The control system has detected a logically impossible state where simultaneous signals indicate both the manual differential lock and the automatic differential lock modes are active at the same time. This invalid combination of inputs typically points to an electrical issue, such as a faulty multi-position switch or a short circuit in the wiring harness, rather than a mechanical failure of the differential lock itself.

Applies to these machines

  • T8 Series
  • T8.275
  • T8.360
  • T8010
  • T9 Series
  • TS Series
  • TS-A Series
  • TS100
  • TS110
  • Magnum Series

Check the cause

  1. Cycle the differential lock switch through Manual, Off, and Auto positions and observe dashboard indicator lights for abnormalities (e.g., light staying on in the wrong position).

  2. Visually inspect the differential lock switch and its rear electrical connector for physical damage, looseness, corrosion, bent pins, or moisture. Clean with electrical contact cleaner if necessary.

  3. Trace the wiring harness from the switch as far as possible, looking for any signs of chafing, pinching, or heat damage, paying close attention to areas where the harness passes through the cab or near moving components.

  4. Test the switch electrically with a multimeter (with the switch disconnected) to ensure continuity only exists for the selected function. Continuity on both 'Manual' and 'Auto' pins in a single position indicates a faulty switch.

  5. Check the wiring harness for short circuits by testing for continuity between the 'Manual' and 'Auto' signal wires (should be an open circuit), as well as checking for shorts to ground or power.

Repair steps

  1. Disconnect battery

    Disconnect the negative terminal of the tractor's battery to prevent short circuits and ensure safety before beginning electrical repairs.

  2. Access the switch

    Remove the necessary portion of the armrest control panel or dashboard trim to access the differential lock switch.

  3. Replace differential lock switch

    If the switch failed the continuity test, carefully remove it from its mounting, install the new switch ensuring it is securely seated, and firmly reconnect the electrical connector.

  4. Repair wiring harness

    If a short circuit was found in the harness, cut out the damaged portion of the wires and splice in new wires of the same gauge using heat-shrink butt connectors or solder and heat-shrink tubing. Secure the repaired harness away from sharp edges or heat sources.

  5. Reassemble and test

    Reassemble the control panel trim, reconnect the battery, turn the key to 'ON', and clear active fault codes. Start the tractor and test the differential lock in all modes to confirm the repair.

Parts you might need

(4)

Get help to fix this fault by requesting a quote

Browse other New Holland codes