6020

New Holland 6020 – Transmission Control Unit (TCU) / Instrument Cluster Controller (EIC or ADIC) / Vehicle Controller: Automatic/Manual Four-Wheel Drive Selector Switch Fault

Issue description

The control system has detected a malfunction related to the four-wheel drive (4WD) selector switch. This indicates an electrical problem, such as a short circuit, an open circuit, or an implausible signal from the switch, which prevents the system from reliably engaging or disengaging the 4WD system. The fault is triggered when the control module receives a signal that is inconsistent with the expected operation of the switch.

Applies to these machines

  • T6000 Series
  • T6020
  • T6030
  • T6050
  • T6070
  • TM Series
  • TM150
  • TS Series
  • TS-A Series

Check the cause

  1. Visually inspect the 4WD selector switch, its connector, and the wiring harness for physical damage, corrosion (white or green buildup), loose connectors, or pinched/frayed wires.

  2. Verify that all fuses related to the transmission, 4WD system, and instrument cluster are intact.

  3. With the key in the 'on' position, operate the 4WD switch and listen for a distinct 'click' from the 4WD solenoid located on the transfer case or front axle. No sound suggests the electrical signal is not reaching the solenoid.

  4. Check for other active fault codes, specifically codes related to the 4WD solenoid (6021, 6022, 6023) or communication errors (6006).

Repair steps

  1. Access Diagnostic 'H' Menu

    On supported models (TS, TM, T6000 series), connect a diagnostic test switch (Tool No. 4FT 950 or equivalent) and turn the key to 'ON'. Navigate to the 'H5' menu for switch testing. Operate the 4WD selector switch; if the display does not change to indicate signal reception, it confirms a fault in the switch or wiring.

  2. Test switch electrical continuity

    Disconnect the electrical connector from the 4WD selector switch. Using a multimeter set to Ohms, test the continuity of the switch terminals while actuating the switch between its positions (Auto, Manual, Off). Resistance should change from an open circuit to a closed circuit (near-zero ohms). If resistance does not change, replace the switch.

  3. Test wiring harness

    With the switch and controller connectors disconnected, use a multimeter to check for continuity on each wire between the switch connector and the corresponding pin at the controller. Test each wire for a short to ground by checking for continuity to a clean chassis ground (there should be none).

  4. Test solenoid circuit

    If the switch and wiring test good, check for voltage at the 4WD solenoid connector when the switch is activated. Measure the resistance of the solenoid coil and compare it to manufacturer specifications.

  5. Component replacement

    Replace the 4WD selector switch or repair the wiring harness as identified during testing. If the switch and wiring are fully functional, the controller (TCU or Instrument Cluster) may require professional diagnosis and potential replacement.

Parts you might need

(5)
  • Listed as a genuine CNH part. Verify correct part number for your specific tractor model and serial number.

  • Listed as a toggle switch for New Holland Agriculture. Verify correct part number for your specific tractor model and serial number.

  • Listed as a New Holland switch. Verify correct part number for your specific tractor model and serial number.

  • Four Wheel Drive Selector Switch Connector

    Available from aftermarket suppliers like NAPA.

  • 2-position rocker switch. CNH Genuine Parts. Direct replacement for TS90, TS100, TS110, TS115, TS6020, and TS6030. Confirm fitment with a dealer using the tractor's serial number for T6000 series.

Get help to fix this fault by requesting a quote

Browse other New Holland codes